COMPUTER DATA LINES – Toyota Tacoma 2008 – SYSTEM WIRING DIAGRAMS

COMPUTER DATA LINES

Computer Data Lines Wiring Diagram for Toyota Tacoma 2008

List of elements for Computer Data Lines Wiring Diagram for Toyota Tacoma 2008:

• (w/ vsc) s1
• (w/o vsc) s1
• 2.7l
• 4.0l
• A/c amplifier (right side of dash)
• A10
• A18
• A21
• Air bag sensor assembly center (in center of dash)
• B17
• B18
• B19
• B20
• Bat
• Canh
• Canl
• Combination meter
• D/a
• D/g
• Data link connector 3 (below left center of dash)
• Ee (4.0l) (right rear of engine compt)
• Eh (2.7l) (rear of cylinder head)
• Engine control module (behind right side of dash)
• Engine room r/b (left front of engine compt)
• Hot at all times
• Ic (center of dash)
• Ign
• Instrument panel j/b 1 (at left side of dash)
• Instrument panel j/b 2 (right side of dash)
• J/c 13 (behind right kick panel)
• J/c 4 & 5 (right side of dash)
• J/c 6, 7, 8, 9, 10 & 11 (right side of dash)
• J10
• J11
• O10
• Obd fuse 7.5a
• Occupant classification ecu (bench: in passenger's seat bottom) (bucket: in front passenger's seat bottom)
• Sil
• Skid control ecu w/ actuator (2.7l w/ vsc: lower left side of dash) (4.0l w/ vsc: left rear of engine compartment) (w/o vsc: right rear of engine compartment)
• St- plug
• Steering sensor (on steering wheel)
• Tac
• Tach
• Tire pressure monitor ecu (center of dash)
• Transponder key ecu (left side of dash)
• W/ bench seat
• W/ seperate seat
• Wfse
• Yaw rate sensor (under passenger seat)