VW LUPO 2003 – Anti-lock brake system (ABS) . Wiring diagrams, Pin Connector, Location

Wiring Diagram VW LUPO 2003 - Battery - ABS control unit with EDL - brake light switch - fuses on battery fuse holder

A	Battery
B	Starter
F	Brake light switch
J...	Engine control units
J104	ABS control unit, on left in engine compartment
J217	Automatic gearbox control unit
M9	Left brake light bulb
M10	Right brake light bulb
SA2	Fuse 2 (30), on battery fuse holder
SA5	Fuse 2 (30), on battery fuse holder
SA6	Fuse 6 (30), on battery fuse holder
SB15	Fuse 15 in relay plate fuse holder
T4g	4-pin connector, black, on battery fuse holder
T10	10-pin connector, white, coupling station under relay carrier
T25	25-pin connector, black, on ABS control unit
1	Earth strap, battery - body
500	Screw connection 1 (30), on relay plat
502	Threaded connection 1 (30a) on relay plate
A32	Positive connection (30), in dash panel wiring harness
B111	Positive connection 1 (30a), in interior wiring harness
B131	Connection (54), in interior wiring harness
D73	Positive connection (54), in engine compartment wiring harness
*	Depends on equipment ⇒ Engine current flow diagram
**	Only models with automatic gearbox

G45	Front right speed sensor
G47	Front left speed sensor
J104	ABS control unit, on left in engine compartment
N99	Front right ABS inlet valve
N100	Front right ABS outlet valve
N101	Front left ABS inlet valve
N102	Front left ABS outlet valve
N133	Rear right ABS inlet valve
T2f	2-pin connector, black, on ABS control unit
T25	25-pin connector, black, on ABS control unit
V64	ABS hydraulic pump, on ABS control unit
12	Earth point, on left in engine compartment
132	Earth connection 3, in engine compartment wiring harness
*	Only with engine code ANY

G44	Rear right speed sensor (00287)
G46	Rear left speed sensor (00290)
J...	Engine control units
J104	ABS control unit, on left in engine compartment
J217	Automatic gearbox control unit
J514	Electronic manual gearbox control unit
N134	Rear left ABS inlet valve
N135	Rear right ABS outlet valve
N136	Rear left ABS outlet valve
T10c	10-pin connector, blue, coupling station under relay carrier
T16	16-pin connector, self-diagnosis connection
T25	25-pin connector, black, on ABS control unit
A76	Connection (K-diagnosis wire), in dash panel wiring harness
D159	Connection (high bus), in engine compartment wiring harness
D160	Connection (low bus), in engine compartment wiring harness
J3	Connection 1, in ABS wiring harness
J5	Connection 2, in ABS wiring harness
J7	Connection 3, in ABS wiring harness
J8	Connection 4, in ABS wiring harness
*	Only models with engine code ANY (Lupo 3L)

D	Ignition/starter switch
J59	X-contact relief relay
J104	ABS control unit, on left in engine compartment
J285	Control unit with display in dash panel insert
K47	ABS warning lamp
SB8	Fuse 8 on relay plate fuse holder
SB9	Fuse 9 on relay plate fuse holder
T10a	10-pin connector, green, coupling station under relay carrier¹)
T25	25-pin connector, black, on ABS control unit
T32	32-pin connector, blue, on dash panel insert
B135	Connection 1 (15a), in interior wiring harness
B138	Positive connection (X), in interior wiring harness
B173	Positive connection 2 (X), in interior wiring harness
B235	Positive connection 4 (15a), in interior wiring harness
*	Applicable to May 1999
**	Valid from May 1999
¹)	Connections, see section "Fitting locations"