| A1 | Second battery |
| E153 | Operating and display unit for camping equipment, near front interior light |
| G18 | Temperature sensor, right C-pillar |
| J65 | Heater control unit, in intake duct |
| T1a | Single connector, behind left upper A-pillar trim |
| T2f | 4-pin connector, left behind lower B-pillar trim |
| T4f | 4-pin connector, behind relay plate |
| T6b | 6-pin connector, behind left upper A-pillar trim |
| T12a | 12-pin connector |
| T12c | 12-pin connector, on intake duct |
| T26 | 26-pin connector |
| TV20 | Terminal 15a junction box -2-, above relay plate |
| 57 | Earth point, left lower B-pillar |
| * | Wire for diagnostic signal |
| F17 | Heater overheating switch, in heater unit |
| G18 | Temperature sensor, in heater unit (not connected in vehicles with camping equipment) |
| G23 | Fuel pump, near heater unit |
| G64 | Flame monitor, in heater unit |
| J65 | Heater control unit, in intake duct |
| J372 | Printed circuit board for temperature sensor, blower motor control unit and glow plug frequency |
| T2 | 2-pin connector |
| T2a | 2-pin connector |
| T4a | 4-pin connector |
| T12 | 12-pin connector |
| T12a | 12-pin connector |
| T12c | 12-pin connector, on intake duct |
| * | Wire has open circuit |
| A1 | Second battery |
| G40 | Hall sender |
| J65 | Heater control unit, in intake duct |
| J372 | Printed circuit board for temperature sensor, blower motor control unit and glow plug frequency |
| Q6 | Glow plug, in heater unit |
| S1 | Fuse in fuse holder/left C-pillar (operating unit fuse) |
| S4 | Fuse in fuse holder/left C-pillar (heating fuse) |
| T1 | Single connector |
| T4 | 4-pin connector |
| T4a | 4-pin connector |
| T12 | 12-pin connector |
| T12a | 12-pin connector |
| T12c | 12-pin connector, on intake duct |
| TV15 | Wiring connector, left behind lower B-pillar trim |
| V81 | Combustion, fresh and hot air blower, in heater unit |
| 57 | Earth point, left lower B-pillar |
| L59 | Positive connection (30), in heater unit wiring harness |
| 253 | Earth connection, in heater unit wiring harness |
| E20 | Switches and instruments - lighting control |
| E111 | Pre-selection clock |
| F4 | Reversing light switch |
| L10 | Dash panel insert light bulb |
| L21 | Light bulb |
| L39 | Heated rear window switch bulb |
| T2b | 2-pin connector, left behind lower B-pillar trim |
| T4f | 4-pin connector, behind relay plate |
| T8 | 8-pin connector |
| T28 | 28-pin connector, on dash panel insert |
| TV5 | Terminal 15a junction box, above relay plate |
| TV8 | Terminal 58b junction box, above relay plate |
| TV21 | Terminal 58b junction box -2-, above relay plate |
| 33 | Earth point, behind dash panel, right |
| A28 | Positive connection (58b), in fresh air blower wiring harness |
Čeština
Dansk
Deutsch
Ελληνικά
English
Español
Suomi
Français
Français
עברית
Hrvatski
Magyar
Italiano
日本語
한국어
Nederlands
Polski
Português
Português
Română
Русский
Slovenčina
Slovenščina
Svenska
Türkçe
中文 (中国)
