DescriptionThe left and right direction indicators are operated by raising or lowering the left lever on the stalk unit. the function is activated with the ignition key in the ON position.The hazard warning lights (right and left direction indicators operated simultaneously) are turned on by the pressing a button in the centre of the dashboard and both the direction indicators come on at the same time. An LED in the back of the button also comes on flashing in synchronization with the outside lights; the function is always activated.The switching on of the direction indicators / hazard warning lights is managed by the Body Computer which also controls the flashing frequency which is sent to the other connectors via the CAN serial network.In this way, the two direction indicator warning lights in the instrument panel are also lit up; in addition, as well as the flashing of the warning lights, the system also produces a low frequency auditory signal., via a relay in the Body Computer.The correct operation of the lights is controlled by the direction indicators 'check' function: the following is controlled for each of the two circuits (right branch and left side):open circuit or 21 W bulb missing (right front, right rear, left front, left rear)short circuit to earth (bulb short circuit or wiring short circuit to earth)short circuit to Vbatt (wiring short circuit to Vbatt)5W bulb replaced with a 21 W bulbIf one of the situations described above is detected, the Body Computer notifies the CAN of the failure state: a special 'lights failure' warning light comes on in the instrument panel and, at the same time, the information is shown on the display. There is also a signal that one of the front or rear 21 W bulbs is missing with an increase in the nominal flashing frequency of the warning lights in the instrument panel and the auditory feedback (buzzer). The direction indicators come on to notify the user that the command to close/open the doors has been received from the remote control 3023301SeeE3040CENTRAL LOCKING3023578SeeE7015ALARM .
Functional description The direction indicators activation signals are sent to pin 7 of connector D and 30 of connector B for the Body Computer M1 from the steering column switch unit H5 . The 'ignition key in ON' signal (INT) for the switch H1 reaches the underdashboard control unit B2 at pin 11 of connector H and from there moves on to the Body Computer M1 (pin 9 of connector F). The hazard warning lights activation signal, on the other hand, reaches pin 34 of connector B of M1 from the control button in the centre panel H12 . The Body Computer M1 controls the supply for the side lights at the side F20 (left) and F21 (rght) from pins 2 and 22 of connector A, for the front side lights F18 (left) F19 (right) from pins 38 and 39 of connector A and for the rear side lights F30 (left) F31 (right) from pins 12 and 3 of connector E. The Body Computer M1 is connected, via the CAN line, to the instrument panel E50, to manage the 'direction indicators' warning light, the buzzer and, if there are failures in the circuit, the 'lights failure' warning light. The signal is sent, from pin 29 of connector B of M1, to light up the LED in the control button H12 .
<anchor>0</anchor><span>Removing</span><icon><imageid>20</imageid></icon>1Refitting213025802-7040A37fuse box cover - r r1. Disconnect the electrical connections at the front (1a, 1b, 1c,1d, 1e, 1f).2. Undo the bolts fixing the control unit.3. Undo the bolts shown fixing the dashboard cover.2004865
<anchor>0</anchor><span>Removing</span><icon><imageid>20</imageid></icon>1Refitting211. Ensure that the ignition key is in the OFF position, then disconnectthe negative battery terminal (-).2. Open the maxi fuse box cover.3. Undo the bolts securing the 'maxi-fuse' box to the battery.4. Loosen the bolt fixing the battery terminal (+).5. Release the maxi fuse box from the battery and move it to theside.2004975
5530B14
Follow these precautions:769768768
5530B18
Follow these precautions.769On batteries with an opticam hydrometer,electrolyte level and battery charge status can be monitored qualitativelyby examining the indicator colour: a light, bright colour indicates low electrolytelevel: top up with distilled water;a dark colour without a green area in thecentre indicates that the electrolyte level is correct but chargeis low: recharge the battery; a dark colour with a green area in themiddle indicates that both electrolyte level and charge status arecorrect: no action is necessary. For further details, see DESCRIPTION ANDOPERATION - 5580.768Proceed as follows.Check the battery voltage without loadusing the test device recommended by the Service outlets (e.g. 'MICRO360'). Depending on the voltage values measured,which define the state of charge of the battery, proceed as follows:If the voltage without load is less than12.10 V, replace the battery (see op.). 5530B10).If the voltage without load is over 12.10V but less than 12.50 V, recharge the battery (see op. 5530B14).If the voltage without load is over 12.50V, the battery is efficient.If necessary, top up the electrolyte asfollows.Carefully remove the cap strip.Top up with distilled and deionized water,taking care not to allow electrolyte to splash out.768
<anchor>0</anchor><span>Removing</span><icon><imageid>20</imageid></icon>1Refitting21Place the vehicle on a lift.Open the bonnet lid.1. Release the retainers (1a) and remove the cover (1b).2004980
5530B40
<anchor>0</anchor><span>Removing</span><icon><imageid>20</imageid></icon>1Refitting21Open the bonnet lid.1. Release the retainers (1a) and remove the cover (1b).2004986
5530B52
<anchor>0</anchor><span>Removing</span><icon><imageid>20</imageid></icon>1Refitting21Proceed with removal 3025534-5530B10battery - r+r .1. Remove the relay/fuse box cover.2. Undo the nut (2a) and disconnect the earth lead (2b) from therelay-fuse box.2004990
5530B60
<anchor>0</anchor><span>Removing</span><icon><imageid>20</imageid></icon>1Refitting213025534-5530B10battery - r+r1. Remove the battery drip tray.2. Unscrew bolts (2a) and loosen bolt (2b) securing the batterycradle.3. Move the battery cradle aside.4. Release the belt retaining stud.5. Remove the belt.2005002
<anchor>0</anchor><span>Removing</span><icon><imageid>20</imageid></icon>1Refitting211. Release the retainers for the switch panel from the dashboardtrim.2. Disconnect the electrical connections.3. Recover the switch panel.2005045
<anchor>0</anchor><span>Removing</span><icon><imageid>20</imageid></icon>1Refitting211. Prise up the side repeater unit at the side indicated.2. Disconnect the electrical connection and recover the led.2005030
<anchor>0</anchor><span>Removing</span><icon><imageid>20</imageid></icon>1Refitting213025915-7055B54under-engine guard -r r1. Disconnect the electrical connection.2. Release the retainers (2a) and remove the direction indicator(2b), extracting it from the front of the vehicle. 2005032
<anchor>0</anchor><span>Removing</span><icon><imageid>20</imageid></icon>1Refitting213025631-5580T30Bose sound system' SUBWOOFER- R.R. (left side only)1. Open the rear light cluster access flap.2. Disconnect the electrical connections.3. Unscrew the nuts.2005004
<anchor>0</anchor><span>Removing</span><icon><imageid>20</imageid></icon>1Refitting211. Using a screwdriver, release the light cluster working on theside shown in the diagram.2. Disconnect the electrical connections.2005006
<anchor>0</anchor><span>Removing</span><icon><imageid>20</imageid></icon>1Refitting213025620-5580E08aerial for alpha code- r r1. Disconnect the electrical connections (1a, 1b) from the ignitionswitch.2. Use a drift and undo the headless bolts (2a); remove the ignitionswitch (2b).7682004913
5520A14
769
5520A16
769
5520A18
<anchor>0</anchor><span>Removing</span><icon><imageid>20</imageid></icon>1Refitting211. If necessary, regulate the steering wheel height adjustment lever.2. Undo the bolts fixing the lower trim.3. Remove the lower trim, releasing it from the inner retainersand the steering wheel.2004920
We use cookies on our website to give you the most relevant experience by remembering your preferences and repeat visits. By clicking “Accept All”, you consent to the use of ALL the cookies. However, you may visit "Cookie Settings" to provide a controlled consent.
This website uses cookies to improve your experience while you navigate through the website. Out of these, the cookies that are categorized as necessary are stored on your browser as they are essential for the working of basic functionalities of the website. We also use third-party cookies that help us analyze and understand how you use this website. These cookies will be stored in your browser only with your consent. You also have the option to opt-out of these cookies. But opting out of some of these cookies may affect your browsing experience.
Necessary cookies are absolutely essential for the website to function properly. This category only includes cookies that ensures basic functionalities and security features of the website. These cookies do not store any personal information.
Any cookies that may not be particularly necessary for the website to function and is used specifically to collect user personal data via analytics, ads, other embedded contents are termed as non-necessary cookies. It is mandatory to procure user consent prior to running these cookies on your website.
Čeština
Dansk
Deutsch
Ελληνικά
English
Español
Suomi
Français
Français
עברית
Hrvatski
Magyar
Italiano
日本語
한국어
Nederlands
Polski
Português
Português
Română
Русский
Slovenčina
Slovenščina
Svenska
Türkçe
中文 (中国)
