Čeština
Dansk
Deutsch
Ελληνικά
English
Español
Suomi
Français
Français
עברית
Hrvatski
Magyar
Italiano
日本語
한국어
Nederlands
Polski
Português
Português
Română
Русский
Slovenčina
Slovenščina
Svenska
Türkçe
中文 (中国)
Components - COURTESY LIGHTS - Fiat DOBLO 1.6 16v da 12/03
The front courtesy light includes two courtesy lights and two control switches; the ones at the rear, however, comprise a single light.The following operating modes can be selected for the front courtesy light using the control switches:- with the left switch in the middle position, the lights go on/off when the doors are opened/closed;- with the left switch pressed towards the left, the lights are constantly off;- with the left switch pressed towards the right, the lights are constantly on;Using the right switch, with the courtesy light off, the left or right light can be turned on individually depending on the position of the actual switch.There are two different timer delay modes to make getting in and out of the vehicle easier.The front courtesy light comes on when entering the vehicle according to the following modes:- for a period of 15 seconds when the front doors are unlocked;- for a period of seven seconds when one of the doors is closed (within three minutes).The timed delay period is always interrupted if the ignition is turned ON.As far as the timed delay period for the courtesy light is concerned when leaving the vehicle (removing the key from the ignition), the coming on of the light follows the logic described below:- it comes on for period of three minutes within two minutes of the engine having been switched off;- for a period of seven seconds when one of the doors is closed (within three minutes).The timed delay period ends automatically when the doors are locked.The operating modes for the rear courtesy lights are as follows depending on the position of the switch:- the lights come on when the tailgate is opened if the switches are in the middle position;- the lights come on irrespective of whether or not the tailgate is opened if the switches are in the right position;- the lights are off permanently with the switches to the left.
The power supply for the front courtesy light G10 reaches pin 2 via the body computer M01.The body computer M01 manages the power supply and the timed delay - respectively from pins 23 and 21 of connector A - via an operating logic determined by the input signals at connector A of the body computer, coming:- from the switch for the left front door lock geared motor N50, to pin 8;- from the switch for the right front door lock geared motor N51, to pin 25.The body computer M01 receives a supply controlled by the ignition and a direct supply at pins 11 of connector E nd pin A of connector C, respectively of the junction unit under the dashboard B02.There is a proective fuse F1 for the direct power supply located in the engine compartment junction unit B01.Pins 8 and 9 of connector D of the body computer are earthed.The supply for the rear courtesy light G20 and the left rear courtesy light G25 - pin 2 - arrives from pin 33 connector A of the body computer via the line protected by fuse F39 of the junction unit under the dashboard B02.Pin 3 of the rear courtesy lights G20 and G25 are connected to the switch on the rear door I21 (boot opening switch I11 in the version with a swing door) and to the switches on the sliding side doors D196 and D197 through which they receive the earth signals when the tailgate or the side doors are opened.All the courtesy lights are earthed via pin 1.