Čeština
Dansk
Deutsch
Ελληνικά
English
Español
Suomi
Français
Français
עברית
Hrvatski
Magyar
Italiano
日本語
한국어
Nederlands
Polski
Português
Português
Română
Русский
Slovenčina
Slovenščina
Svenska
Türkçe
中文 (中国)
Components - REVERSING LIGHTS - Fiat DOBLO 1.6 16v da 12/03
| Component code | Description | Reference to the assembly |
| B001 | JUNCTION UNIT | |
| B2 | JUNCTION UNIT UNDER DASHBOARD | |
| C15 | DASHBOARD EARTH, DRIVER''S SIDE | |
| C030 | LEFT REAR EARTH | |
| F030 | LEFT REAR LIGHT CLUSTER | |
| F031 | RIGHT REAR LIGHT CLUSTER | |
| H001 | IGNITION SWITCH | |
| I020 | REVERSING LIGHTS SWITCH | |
| M001 | BODY COMPUTER |
| Component code | Description | Reference to the assembly |
| B001 | JUNCTION UNIT | |
| B2 | JUNCTION UNIT UNDER DASHBOARD | |
| C15 | DASHBOARD EARTH, DRIVER''S SIDE | |
| C030 | LEFT REAR EARTH | |
| F030 | LEFT REAR LIGHT CLUSTER | |
| F031 | RIGHT REAR LIGHT CLUSTER | |
| H001 | IGNITION SWITCH | |
| I020 | REVERSING LIGHTS SWITCH | |
| M001 | BODY COMPUTER |
The vehicle is equipped with reversing lights located in the tail-light clusters.These are operated whenever reverse is engaged via a switch on the outside of the gear housing.The circuit is supplied with the key on MAR and protected by a fuse located in the underfacia junction unit.The reversing light activation signal is managed by the Body Computer, which forwards this information:- to the Parking Sensor Control Unit;- and to the Radio Navigation System;- while also inhibiting the seat belt buzzer.
The reversing light activation signal leaves switch I020, located in gear casing, ignition-operated (INT/A) via a connection between ignition switch H01 and pin 1 connector E of under-facia junction unit B02.The line is protected by fuse F31 in the control unit (B02) and via engine compartment control unit B01, entering at pin 11 connector B and leaving at pin 9 connector B.When reverse is engaged, the switch closes and the reversing lights in the right tail-light F31 and left tail-light F30 are supplied with power via pin 8 of connector D of under-dashboard control unit B02.At the same time, this power supply is sent to body computer M01 for associated logic functions.The body computer is supplied via pin 11 connector E of junction unit B02 from ignition switch H01 (INT) or via a line protected by fuses F53 and F1 contained in control unit B02 and B01 and lastly directly from the battery via a fuse F1 in engine compartment junction unit B01.Pins 8 and 9 of connector D of the body computer are earthed.
