Wiring diagram - ADDITIONAL HEATER - Fiat STILO 1.9 JTD 8v da 01/04
Components - ADDITIONAL HEATER - Fiat STILO 1.9 JTD 8v da 01/04
Component code | Name | Assembly reference |
B1 | Engine compartment junction unit | |
B38 | Additional heater fuse | - |
B99 | Maxifuse box on battery | |
I95 | Additional heater safety switch | - |
J36 | Additional heater relay | - |
J37 | Additional heater relay - 2 | - |
J37 | Additional heater relay -2 | - |
K79 | Air temperature sensor (additional heater)( | - |
K79 | Air temperature sensor (additional heater)() | - |
M70 | Climate control system control unit | |
N85 | Passenger compartment ventilation fan | |
O25 | Additional heater resistor | - |
Location of components - ADDITIONAL HEATER - Fiat STILO 1.9 JTD 8v da 01/04
Components - ADDITIONAL HEATER - Fiat STILO 1.9 JTD 8v da 01/04
Component code | Name | Assembly reference |
B1 | Engine compartment junction unit | |
B38 | Additional heater fuse | - |
B99 | Maxifuse box on battery | |
I95 | Additional heater safety switch | - |
J36 | Additional heater relay | - |
J37 | Additional heater relay - 2 | - |
J37 | Additional heater relay -2 | - |
K79 | Air temperature sensor (additional heater)( | - |
K79 | Air temperature sensor (additional heater)() | - |
M70 | Climate control system control unit | |
N85 | Passenger compartment ventilation fan | |
O25 | Additional heater resistor | - |
Description - ADDITIONAL HEATER - Fiat STILO 1.9 JTD 8v da 01/04
The climate control via the heater unit is insufficient when the engine is cold, especially in Diesel engines which are slow to warm up.These engines may optionally be fitted with a supplementary heater system. This remains active from the moment when the engine is turned on until a certain temperature is reached.The system consists of an additional heater, located in the heater unit: the device contains three resistances (PTC).
Functional description - ADDITIONAL HEATER - Fiat STILO 1.9 JTD 8v da 01/04
The relay J36 controls the engagement of the first additional heater coilThe relay is supplied from the line of the fuse B38 .The relay J37 controls the engagement of the other two additional heater coils. The supply for relay arrives from the line for maxifuse PTC2, located on the battery, connector B99 .the ignition (INT/A) protected by fuse F49 of the junction unit under the dashboard B2. The climate control unit M70 sends the enabling signal for engaging the first resistance O25A from pin 8 of connector B: this signal excites relay J36. The climate control unit M70 sends a signal for enabling the engagement of the two resistances O25B from pin 7 of connector B: this signal energizes the relay J36.