AIR CONDITIONING – Mazda 626 LX 2002 – SYSTEM WIRING DIAGRAMS

AIR CONDITIONING

Manual A/C Wiring Diagram for Mazda 626 LX 2002

List of elements for Manual A/C Wiring Diagram for Mazda 626 LX 2002:

• (behind left kick panel) g4
• (near right side of radiator grille)
• A/c fuse 10a
• A/c relay (on main fuse block, in engine compartment)
• Ad fan fuse 30a
• Air intake actuator
• Air mix actuator (behind lower center of dash)
• Airflow mode actuator (behind lower center of dash)
• B/l
• Blower motor
• Blower relay (on left side of engine compartment)
• Blower unit
• Climate control unit
• Cold
• Condenser fan (on right front of engine compartment)
• Condenser fan relay (on left front inner fender panel, near main fuse block)
• Cooling fan fuse 30a
• Cooling fan motor (on left front of engine compartment)
• Cooling fan relay (on left front inner fender panel, near main fuse block)
• Engine fuse 10a
• Fan switch
• Fre
• H/d
• Heater fuse 40a
• Hot
• Hot at all times
• Hot in run
• Hot in run or start
• Interior lights system
• Jb-01
• Jb-05
• Jb-06
• Jc-02
• Joint box (behind left side of dash)
• Magnetic clutch
• Main fuse block (on left front inner fender panel, in engine compartment)
• Off
• Pnk
• Powertrain control module (pcm) (under center console)
• Rec
• Red
• Refrigerant pressure switch (high) (on front center of engine compartment, near condenser)
• Refrigerant pressure switch (low) (on right rear corner of engine compartment)
• Resistor
• Room fuse 15a
• Swing louver (behind center of dash)
• Thermal protector (on left front of engine, near a/c compressor)
• Wiper fuse 20a