ANTI-LOCK BRAKES – Chevrolet Cavalier RS 1997 – SYSTEM WIRING DIAGRAMS

ANTI-LOCK BRAKES

Anti-lock Brake Wiring Diagrams for Chevrolet Cavalier RS 1997

List of elements for Anti-lock Brake Wiring Diagrams for Chevrolet Cavalier RS 1997:

• (left center of engine compt)
• (left rear of engine compt)
• A10
• A11
• A12
• Abs actuator motor assembly (below master cylinder)
• Abs fuse 20a
• Abs fuse 40a
• Abs ind.
• B12
• Batt
• Brake
• Brake fluid level switch (in brake fluid reservoir)
• Brake in
• Brake level in
• Brake switch (on brake pedal support bracket)
• Cluster fuse 10a
• Data line
• Data link connector (dlc) (below left side of dash)
• Electronic brake control module (ebcm) (behind lower left side of dash, near fuse block)
• Electronic brake control relay
• Enable rly output
• Erls fuse 10a
• Fuse block
• G104
• Ground
• Hot at all times
• Hot in run, bulb test or start
• Ign
• Ind.
• Ind. ctrl
• Instrument panel cluster
• L fnt mtr-hi
• L fnt mtr-lo
• Left fnt wheel spd
• Left front abs solenoid
• Left front motor
• Left front wheel speed sensor
• Left rear wheel spd
• Left rear wheel speed sensor
• Left solenoid
• Microprocessor
• Pnk
• Rear motor
• Rear mtr-hi
• Rear mtr-lo
• Red
• Right front abs solenoid
• Right front motor
• Right front wheel speed sensor
• Right rear wheel speed sensor
• Rly coil ctrl
• Rt fnt mtr-hi
• Rt fnt mtr-lo
• Rt fnt solenoid
• Rt fnt wheel spd
• Rt rear wheel spd
• S102
• S203
• S206 (left lower dash)
• S210
• S214
• S277 (left lower dash)
• Stop/haz fuse 20a
• Tan
• Underhood compartment fuse/relay center