ANTI-LOCK BRAKES – Chevrolet Pickup K1500 1999 – SYSTEM WIRING DIAGRAMS

ANTI-LOCK BRAKES

Anti-lock Brake Wiring Diagrams for Chevrolet Pickup K1500 1999

List of elements for Anti-lock Brake Wiring Diagrams for Chevrolet Pickup K1500 1999:

• 4wd sw input
• Abs fuse 60a
• Abs ind
• Abs ind ground
• Battery
• Brake fuse 18 10a
• Brake ind
• Brake ind input
• Brake lamp ind out
• Brake pressure warning switch (underside of ebcm)
• Brake sw input
• Brake sw output
• Cruise control system
• Data link connector (left of steering column)
• Daytime running lamps module (behind left side of dash)
• Ebcm ground
• Electronic brake control module (left side of engine compt)
• Engine control system
• Evo/ passlock control module (under center of dash)
• Front axle actuator (right front of front axle)
• G119 (right front of engine)
• Gauges fuse 4 10a
• Hot at all times
• Hot in run
• Hot in run and start
• I/p fuse block (under left side of dash)
• Ignition
• Instrument cluster
• Left front wheel speed sensor
• M/t only
• Pnk
• Pump motor ground
• Red
• Right front wheel speed sensor
• S147
• S150 (engine harn, approx 13 cm from ebcm breakout)
• S151
• S152 (engine harness, near ebcm breakout)
• S213
• S280 (i/p harn, approx 5 cm from dlc breakout)
• Sensor high
• Sensor low
• Serial data
• Serial data line
• Stoplamp switch (top of brake pedal)
• Tan
• Transfer case shift control module (on steering column support bracket)
• Underhood fuse/relay center (left rear of engine compt)
• Vehicle control module (left side of engine compt)
• Vehicle speed sensor (left side of transmission/ transfer case)
• Vehicle speed sig
• Vss (+)
• Vss (-)
• Vss sig