ANTI-LOCK BRAKES – Chevrolet Suburban C2500 2001 – SYSTEM WIRING DIAGRAMS

ANTI-LOCK BRAKES

Anti-lock Brake Wiring Diagrams, with Traction Control for Chevrolet Suburban C2500 2001

List of elements for Anti-lock Brake Wiring Diagrams, with Traction Control for Chevrolet Suburban C2500 2001:

• A4 c1
• Abs fuse 60a
• Abs ind
• Body wiring harness junction block (under left side of dash, near kick panel)
• Brake fluid level sw in
• Brake fluid level switch (on left side of brake fluid reservoir)
• Brake fuse 10a
• Brake in
• Brake ind
• Brake input
• C8 a
• Data link connector (dlc) (below steering column)
• Del torque
• Delivered torque
• Electronic brake control module (ebcm) (on left side of inner frame)
• Engine wiring harness junction block (at left side of engine compt, near battery)
• F6 c3
• F7 c2
• Fuse block (on lower left side of dash)
• G113 (left front body mount)
• G132 (right front of engine block)
• G202 (upper left side of dash, at "a" pillar)
• Ground
• Ground distribution system
• Hot at all times
• Hot in run
• Hot in run or start
• Ign 1 fuse 10a
• Ignition
• Illum lamp
• Instrument cluster
• Interior lights system
• Left front sensor (+)
• Left front sensor (-)
• Left front wheel speed sensor
• Logic
• Low traction indicator
• Motor & solenoid pwr
• Nca
• Pnk
• Power distribution system
• Powertrain control module (pcm) (on left front of engine compt)
• Red
• Req torque
• Requested torque
• Right front sensor (+)
• Right front sensor (-)
• Right front wheel speed sensor
• S102
• Serial data
• Service trac cntl sig
• Sp203
• Splice pack sp203 (on top left side of dash, near "a" pillar)
• Stoplight switch (on top of brake pedal bracket)
• Tan
• Trac cntl active sig
• Trac sw input
• Traction control switch
• Traction off indicator
• Vehicle speed sensor (vss) (4wd: on top left side of transfer case) (2wd: on left rear side of transmission)
• Vehicle speed sensor adapter (4wd only) (on left side of trans)
• Vss high
• Vss input
• Vss low
• Vss out

Anti-lock Brake Wiring Diagrams, without Traction Control for Chevrolet Suburban C2500 2001

List of elements for Anti-lock Brake Wiring Diagrams, without Traction Control for Chevrolet Suburban C2500 2001:

• A4 c1
• Abs fuse 60a
• Abs ind
• Body wiring harness junction block (under left side of dash, near kick panel)
• Brake fluid level sw in
• Brake fluid level switch (on left side of brake fluid reservoir)
• Brake fuse 10a
• Brake ind
• Brake input
• C8 a
• Data link connector (dlc) (below steering column)
• Electronic brake control module (ebcm) (on left side of inner frame)
• Engine control system
• Engine wiring harness junction block (at left side of engine compt, near battery)
• F6 c3
• F7 c2
• Front axle act/sw input
• Front axle actuator/ switch (on axle housing)
• Fuse block (on lower left side of dash)
• G113 (left front body mount)
• G132 (right front of engine block)
• Ground
• Hot at all times
• Hot in run
• Hot in run or start
• Ign 1 fuse 10a
• Ignition
• Instrument cluster
• Left front sensor (+)
• Left front sensor (-)
• Left front wheel speed sensor
• Logic
• Motor & solenoid pwr
• Nca
• Pnk
• Power distribution system
• Powertrain control module (pcm) (on left front of engine compt)
• Red
• Right front sensor (+)
• Right front sensor (-)
• Right front wheel speed sensor
• S102
• Serial data
• Splice pack sp205 (on left side of dash, behind headlamp switch)
• Stoplight switch (on top of brake pedal bracket)
• Tan
• Transfer case shift control module (left side of dash, behind headlamp switch)
• Vehicle speed sensor (vss) (4wd: on top left side of transfer case) (2wd: on left rear side of transmission)
• Vehicle speed sensor adapter (4wd only) (on left side of trans)
• Vss high
• Vss input
• Vss low
• Vss output