ANTI-LOCK BRAKES – Chevrolet Tracker 2000 – SYSTEM WIRING DIAGRAMS

ANTI-LOCK BRAKES

Anti-lock Brake Wiring Diagrams for Chevrolet Tracker 2000

List of elements for Anti-lock Brake Wiring Diagrams for Chevrolet Tracker 2000:

• (a/t) (m/t)
• (main harness)
• (pin b8 not used)
• (pins b2-b6 not used)
• (pins c1-c5 not used)
• (under rear floor console)
• 4wd ind
• 4wd signal
• A10
• A11
• Abs fuse 50a
• Abs ind
• Abs ind control
• Accelerometer (4wd only)
• Battery
• Brake fluid level switch (on brake fluid reservoir)
• Brake ind
• Brake pressure modulator valve (bpmv)
• Data link connector
• Def fuse 15a
• Electronic brake control module (ebcm) (at left rear corner of eng compt)
• Electronic brake control relay
• Exterior lights system
• Fuse box
• Ground
• Hot at all times
• Hot in on or start
• Idle up signal
• Ig fuse 20a
• Instrument cluster
• Junction block
• Left front inlet solenoid valve
• Left front outlet solenoid valve
• Left front signal high
• Left front signal low
• Left front wheel speed sensor
• Left rear wheel speed sensor
• Nca
• Powertrain control module (under right side of dash)
• Pump motor
• Right front inlet solenoid valve
• Right front outlet solenoid valve
• Right front signal high
• Right front signal low
• Right front wheel speed sensor
• Right rear inlet solenoid valve
• Right rear outlet solenoid valve
• Right rear signal high
• Right rear signal low
• Right rear wheel speed sensor
• S202
• S205
• S213
• S241
• S248
• S250
• S259
• S264
• S265
• S266
• Serial data line
• Signal
• Sp200 ground pack
• Stop fuse 15a
• Stop- lamp switch input
• Stoplamp switch (above brake pedal)