ANTI-LOCK BRAKES – Chrysler PT Cruiser 2005 – SYSTEM WIRING DIAGRAMS

ANTI-LOCK BRAKES

Anti-lock Brakes Wiring Diagram for Chrysler PT Cruiser 2005

List of elements for Anti-lock Brakes Wiring Diagram for Chrysler PT Cruiser 2005:

• (at left side of engine compt, on bottom of hydraulic control unit) anti-lock brake module
• (left front inner fender)
• (left side of instrument panel) instrument cluster
• (near breakout for c212)
• (near data link connector) s126
• (under left side of dash, near kick panel) data link connector
• A10
• A20
• Abs ind
• Abs ind ctrl
• B27
• Brake lamp sw out
• Brake lamp switch (on brake pedal bracket)
• Computer data lines system
• D223
• D25
• Exterior lights system
• F12
• Fuse (+)
• Fuse 10 10a
• Fuse 11 10a
• Fuse 12 15a
• Fuse 2 40a
• Fuse 7 30a
• Fuse block (at lower left front of dash)
• Fused b (+)
• Fused ign (run/start)
• G105
• G200 (behind center of dash)
• Ground
• Hot at all times
• Hot in run
• Interior lights system
• L50
• Left front wheel speed sensor (left front wheel opening)
• Left rear wheel speed sensor (in left rear wheel opening)
• Lf whl spd sens 12v
• Lf whl spd sens sig
• Lr whl spd sens 12v
• Lr whl spd sens sig
• Not used
• Or start
• Pci bus
• Power distribution center (on left side of engine compt)
• Red
• Rf whl spd sens 12v
• Rf whl spd sens sig
• Right front wheel speed sensor (right front wheel opening)
• Right rear wheel speed sensor (in right rear wheel opening)
• Rr whl spd sens 12v
• Rr whl spd sens sig
• S125
• S201
• S224
• Traction control switch
• Traction ctrl sw sen
• Traction off ind ctrl
• Traction off indicator