ANTI-LOCK BRAKES – Chrysler Sebring JX 2000 – SYSTEM WIRING DIAGRAMS

ANTI-LOCK BRAKES

Anti-lock Brake Wiring Diagrams for Chrysler Sebring JX 2000

List of elements for Anti-lock Brake Wiring Diagrams for Chrysler Sebring JX 2000:

• (1999)
• (2000)
• A10
• A20
• Abs lamp driver
• Abs warning lamp
• Battery
• Body control module (on junction block, under left side of dash)
• Brake shift interlock solenoid (2000)
• Ccd bus (+)
• Ccd bus (-)
• Controller anti-lock brake (on top of front suspension crossmember)
• F12
• F18
• Fuse 10 10a
• Fuse 13 40a
• Fuse 2 20a
• Fuse 4 20a
• Fuse 9 10a
• G100 (left front corner of engine compt)
• G19
• Ground
• Hot at all times
• Hot in run or start
• Ignition
• Instrument cluster
• Junction block (under left side of dash)
• L50
• Left front wheel speed sensor (attached to left knuckle boss)
• Left rear wheel speed sensor (attached to left brake support plate)
• Lt ft whl spd (+)
• Lt ft whl spd (-)
• Lt rear whl (+)
• Lt rear whl (-)
• Power distribution center (on left front inner fender)
• Red
• Right front wheel speed sensor (attached to right knuckle boss)
• Right rear wheel speed sensor (attached to right brake support plate)
• Rt ft whl spd (+)
• Rt ft whl spd (-)
• Rt rear whl (+)
• Rt rear whl (-)
• S105
• S106
• S140
• S141
• Sentry key immobilizer module (on steering column)
• Stoplight sw
• Stoplight switch (top of brake pedal)
• Transmission control module (left front of inner fender)
• Traveler (1999)