ANTI-LOCK BRAKES – Chrysler Sebring LX 2004 – SYSTEM WIRING DIAGRAMS

ANTI-LOCK BRAKES

Anti-lock Brakes Wiring Diagram for Chrysler Sebring LX 2004

List of elements for Anti-lock Brakes Wiring Diagram for Chrysler Sebring LX 2004:

• 2.7l
• A10
• A20
• Abs warning ind control
• Abs warning indicator
• Body control module (at left kick panel)
• Brake fluid level switch (at left rear of engine compt)
• Brake lamp sw
• Brake lamp switch (at top of brake pedal assembly)
• Brake warning ind
• Brake warning ind driver
• Brake warning indicator
• Controller anti-lock brake (at lower left front of engine compt)
• D25
• Daytime running lamp module
• F20
• Fuse 10a
• Fuse 15a
• Fuse 20a
• Fuse 40a
• Fuse ign sw (run)
• Fused b (+)
• Fused ign sw input
• G103 (near left front strut tower)
• G113 (near left headlight)
• Ground
• Hot at all times
• Hot in run
• Hot in run or start
• Instrument cluster
• Jucntion block (left end of dash)
• Junction block (left end of dash)
• L50
• Left front wheel speed sensor (at left side of engine compt)
• Left rear wheel speed sensor (at left rear wheelwell)
• Lf whl spd 12v
• Lf whl spd sig
• Lr whl spd 12v
• Lr whl spd sig
• M/t
• Park brake switch (at base of parking brake lever)
• Pci bus
• Power distribution center (on left front inner fender)
• Powertrain control module (left front of engine compt)
• Red
• Rf whl spd 12v
• Rf whl spd sig
• Right front wheel speed sensor (at right side of engine compt)
• Right rear wheel speed sensor (at right rear wheelwell)
• Rr whl spd 12v
• Rr whl spd sig
• S126
• S210
• Sens sig
• Speed sens sig
• Twisted pair
• Vehicle speed
• Z101
• Z102