ANTI-LOCK BRAKES – Dodge Dakota 2001 – SYSTEM WIRING DIAGRAMS

ANTI-LOCK BRAKES

Anti-lock Brake Wiring Diagrams for Dodge Dakota 2001

List of elements for Anti-lock Brake Wiring Diagrams for Dodge Dakota 2001:

• (under dash, left of steering column)
• A10
• A20
• B10
• B113
• B114
• Brake lamp switch (on brake pedal bracket)
• Brake light sw sense
• Brake pressure switch
• Brake pressure switch (in brake system combination valve)
• Controller anti-lock brake (abs: on top of hydraulic control unit, rwal: in eng compt, on left inner fender panel)
• Data link connector
• Diagnostic junction port (under dash, right of steering column)
• Fuse 15a
• Fuse 40a
• Fused b+
• G111 (near battery)
• G206 (lower center of dash)
• Ground
• Hot at all times
• Hot in run
• J/c 2 (in pdc)
• Junction block (on left end of dash)
• Left front sensor (+)
• Left front sensor (-)
• Left front wheel speed sensor (w/ all wheel abs) (on left steering knuckle)
• Pci bus
• Power distribution center (in engine compartment, on left inner fender panel)
• Powertrain control module (in eng compt, on right inner fender panel)
• Powertrain control module (in engine compt, on right inner fender panel)
• Rear wheel sensor (+)
• Rear wheel sensor (-)
• Rear wheel speed sensor (on top of differential housing)
• Red
• Right front sensor (+)
• Right front sensor (-)
• Right front wheel speed sensor (w/ all wheel abs) (on right steering knuckle)
• S126
• S174 (near powertrain control module)
• Stoplight sw sense sig
• Transmission control module (in right front engine compt, on radiator core support)
• V40
• Vehicle speed sig
• W/ a/t
• W/ all wheel abs
• Z19