ANTI-LOCK BRAKES – Ford Expedition 2002 – SYSTEM WIRING DIAGRAMS

ANTI-LOCK BRAKES

Anti-lock Brake Wiring Diagrams for Ford Expedition 2002

List of elements for Anti-lock Brake Wiring Diagrams for Ford Expedition 2002:

• 4-wheel anti-lock brake system (4wabs) module (left side of engine compt)
• 4wabs ind ctrl
• Abs active input
• Active a4wd input
• Anti- lock ind
• Battery junction box (on left side of engine compartment)
• Bias ckt
• Bpp switch feed
• Brake fluid level indicator switch (on brake fluid reservoir)
• Brake fluid level sw
• Brake pedal position (bpp) switch (behind left side of dash)
• C146
• C238
• C240
• C241
• C242
• C243
• Central junction box (under left side of dash)
• Computer data lines system
• Data link connector (behind center of dash)
• Diagnostic circuit
• Differential speed sensor (dss) (on rear axle)
• Fuse 10a
• Fuse 50a
• Fuse 5a
• G104 (left front radiator support)
• G201 (lower left kick panel)
• Generic electronic module (gem)
• Ground
• Hot at all times
• Hot in run
• Ignition feed
• Instrument cluster
• Left front sensor (high)
• Left front sensor (low)
• Left front wheel 4wabs sensor (at wheel)
• Nca
• Ohm
• Power input
• Processor micro-
• Rear sensor (high)
• Rear sensor (low)
• Red/pnk
• Right front sensor (high)
• Right front sensor (low)
• Right front wheel 4wabs sensor (at wheel)
• S105 (engine sensor harn, near breakout to 4wabs module)
• S106
• S107
• S130 (engine sensor harn, left rear corner of engine compartment)
• S156 (engine sensor harn, near breakout to 4wabs module)
• S208 (engine sensor harn, left side of dash)
• S229 (main harness, near breakout to cluster)
• S265
• Tan/red