ANTI-LOCK BRAKES – Ford Explorer 1995 – SYSTEM WIRING DIAGRAMS

ANTI-LOCK BRAKES

Anti-lock Brake Wiring Diagrams for Ford Explorer 1995

List of elements for Anti-lock Brake Wiring Diagrams for Ford Explorer 1995:

• 4wabs control module (left rear corner of engine compartment)
• 4wabs hydraulic unit (left side of engine compartment)
• 4wabs main relay
• 4wabs pump motor (left side of engine compt)
• 4wabs pump relay
• Abs diode
• Acceleration sensor (left frame rail, under driver seat)
• Anti-lock brakes indicator
• Auxiliary relay box #1
• Brake on/off (boo) switch (on brake pedal support)
• Brake on/off sw feed
• Data link connector (behind left side of i/p)
• Dump valve
• Exterior lights system
• Fuse 10a
• Fuse 15a
• Fuse 30a
• G-switch #1
• G-switch status
• G104 (left rear corner of engine compt, at fender apron)
• G108 (left front of engine compartment, near radiator)
• Gem iso link
• Generic electronic module (gem) (behind center of i/p)
• Ground
• Hot at all times
• Hot in run
• Hot in run or start
• Ignition
• Instrument cluster
• Interior fuse panel
• Iso valve
• L fnt dump valve
• L fnt iso valve
• L fnt sensor (hi)
• L fnt sensor (lo)
• Left front
• Left front wheel 4wabs sensor
• Motor speed sens #2
• Nca
• Pnk
• Power distribution box
• Powertrain control module (at right kick panel)
• Pump motor rly coil (-) g-switch #2
• Rear
• Rear axle sensor
• Rear dump valve
• Rear iso valve
• Rear sensor (hi)
• Rear sensor (lo)
• Red/pnk
• Relay coil (-)
• Right front
• Right front wheel 4wabs sensor
• Rt fnt dump valve
• Rt fnt iso valve
• Rt fnt sensor (hi)
• Rt fnt sensor (lo)
• Tan
• Tan/ red
• Tan/red
• Vehicle power
• Warning lamp