ANTI-LOCK BRAKES – Isuzu Trooper LS 1998 – SYSTEM WIRING DIAGRAMS

ANTI-LOCK BRAKES

Anti-lock Brake Wiring Diagrams for Isuzu Trooper LS 1998

List of elements for Anti-lock Brake Wiring Diagrams for Isuzu Trooper LS 1998:

• "abs" indicator light
• (s model)
• 4wd engaged input
• 4wd engaged output
• A/t
• Abs active input
• Abs active output
• Abs ind lt ctrl
• B-48
• B-49
• Back-up light switch (on right side of trans- mission)
• Battery
• Braided wire
• Brake input
• Brake switch (on brake pedal support)
• C-1
• C-10 meter gauge fuse 10a
• C-14 stoplight a/t cont fuse 15a
• C-3 turn back fuse 15a
• C-4 elec ign fuse 15a
• Dash fuse box (behind left kick panel)
• Dash, above engine hood release lever)
• Data link connector (dlc) (left side of
• Diode box a
• Dlc input/output
• Electronic brake control module (ebcm) (right front of engine compartment)
• Engine compart- ment) g101
• F-9 abs fuse 20a
• Fl-6 (abs 4/wheel only) fuse 40a
• Fuse/relay box (on right side of engine compartment)
• G sensor input
• G sensor- abs (rear of park brake lever)
• G105 (right rear corner of engine compartment, on inner fender panel)
• Gnd
• Ground
• Hot at all times
• Hot in on or start
• I-10
• I-9
• Ignition
• Left front abs speed sensor (inside of left front wheel)
• Left rear abs speed sensor (inside of left rear wheel)
• M/t
• Meter assembly
• Nca
• Pnk
• Powertrain control module (pcm) (behind center of dash, below radio)
• Red
• Rev/low gear in
• Reverse or l range output
• Right front abs speed sensor (inside of right front wheel)
• Right rear abs speed sensor (inside of right rear wheel)
• Torque on demand (tod) control unit (beneath front passenger's seat)
• Transmission switch 1st/2nd (on right front of transmission)
• Wheel spd in (hi)
• Wheel spd in (lo)