ANTI-LOCK BRAKES – Isuzu Trooper SE 1994 – SYSTEM WIRING DIAGRAMS

ANTI-LOCK BRAKES

All-Wheel ABS Wiring Diagram (1 of 2) for Isuzu Trooper SE 1994

List of elements for All-Wheel ABS Wiring Diagram (1 of 2) for Isuzu Trooper SE 1994:

58

• (at parking
• (behind center
• (in master
• (mounted on brake
• 4wd ind.
• 4wd switch in
• Abs aldl
• Abs aldl connector (left kick panel)
• Abs ind. ctrl
• Anti- lock ind.
• Braided wire
• Brake
• Brake fluid
• Brake ind.
• Brake switch
• Brake switch in
• C214
• Charging system
• Cluster
• Conn, in/out
• Console)
• Cylinder
• Dash fuse box (left i/p)
• Electronic brake control module (behind front console)
• Fuse 10a
• Fuse 15a
• Fuse 7.5a
• G sensor in
• G-sensor (below rear of center console)
• G206 (right of center console)
• Ground
• Hot at all times
• Hot in on or start
• Ignition
• Indicators
• Instrument
• Left front abs speed sensor (inside of left front wheel)
• Left rear abs speed sensor (inside of left rear wheel)
• Level switch
• Lf valve ctrl
• Motor relay ctrl
• Parking
• Pedal
• Pnk
• Pump motor run in
• Rear valve ctrl
• Red
• Release)
• Reservoir)
• Reverse in
• Rf valve ctrl
• Right front abs speed sensor (inside of right front wheel)
• Right rear abs speed sensor (inside of right rear wheel)
• Support)
• Valve relay ctrl
• Valve relay in
• Wheel speed in-hi
• Wheel speed in-lo

All-Wheel ABS Wiring Diagram (2 of 2) for Isuzu Trooper SE 1994

List of elements for All-Wheel ABS Wiring Diagram (2 of 2) for Isuzu Trooper SE 1994:

34

• (left rear corner of engine compt)
• (right side of engine compt)
• 4wd indicator switch (right side of transfer case)
• A/t
• Abs & upshift relay
• Abs hydraulic unit
• All times
• B10
• Back up light switch
• C103
• C104
• Clutch switch
• Dash fuse box (left
• Diode box a
• Fuse 20a
• Fuse c-4 10a
• Fuse/ relay box (right side engine compt)
• Fusible link 6 40a
• G116
• Hot at
• Hot in on or start
• I/p)
• Left front valve
• M/t
• Motor relay
• Pump motor
• Rear valve
• Red
• Red/
• Right front valve
• Transmission control module (left kick panel)
• Transmission switch 1-2 (left side of transmission)
• Upshift indicator
• Valve relay

Rear Wheel ABS Wiring Diagram for Isuzu Trooper SE 1994

List of elements for Rear Wheel ABS Wiring Diagram for Isuzu Trooper SE 1994:

57

• (left rear corner of engine compt)
• (mounted on brake
• (not used)
• 4wd ind.
• 4wd indicator switch (right side of transfer case)
• 4wd switch in
• Battery in
• Brake ind.
• Brake ind. ctrl
• Brake light
• Brake switch in
• Brake valve (right front
• Charging system
• Combination valve pressure differential switch (in brake fluid valve)
• Dash fuse box (left
• Dash fuse box (left i/p)
• Diagnostic test connector (left kick panel)
• Differential speed sensor (on top of differential)
• Diode box 5
• Dtc in
• Dump solenoid
• Dump solenoid ctrl
• Engine compt)
• Fuse 15a
• Fuse 20a
• Fuse 7.5a
• Fuse/ relay box (right side engine compt)
• G101 (right front engine compt)
• G116
• G206 (right of center console)
• Ground
• Hot at all times
• Hot in on
• Hot in on or start
• I/p)
• Ignition in
• Indicators
• Instrument cluster
• Iso solenoid ctrl
• Isolation solenoid
• Ls & rs models
• Or acc
• Pedal
• Pnk
• Press. switch in
• Rabs ind. ctrl
• Rear wheel anti-lock
• Rear wheel anti-lock brake controller (behind front console)
• Red/
• Reset switch
• Reset switch in
• Rr. anti- lock brake ind.
• Speed sensor-hi
• Speed sensor-lo
• Support)
• Switch
• Test connector (left kick panel)