ANTI-LOCK BRAKES – Jeep Cherokee Classic 1998 – SYSTEM WIRING DIAGRAMS

ANTI-LOCK BRAKES

Anti-lock Brake Wiring Diagrams for Jeep Cherokee Classic 1998

List of elements for Anti-lock Brake Wiring Diagrams for Jeep Cherokee Classic 1998:

• (i/p harn, near breakout to brake switch) s203
• A10
• A20
• Abs ind
• Abs relay control
• Accel sensor 1
• Accel sensor 2
• B16
• B18
• B19
• B20
• B41
• B42
• B43
• Battery
• Computer data lines
• Controller anti-lock brake (on hydraulic unit)
• Controller anti-lock brake relay (in power distribution center)
• D21
• Data link connector (bottom of knee bolster, left of steering column)
• Exterior lights
• F15
• Fuse 10a
• Fuse 15a
• Fuse 20a
• Fuse 40a
• Fused ign (run)
• G switch (below left rear seat)
• G100 (fender side shield, near pcm)
• G115 (rear of engine compartment)
• G83
• Ground
• Hot at all times
• Hot in run
• Hot in run and start
• Instrument cluster
• Junction block
• L50
• Left front wheel speed sensor (on left front steering knuckle)
• Left rear wheel speed sensor (on left end of rear axle)
• Lf wheel spd sens +
• Lf wheel spd sens -
• Lr wheel spd sens +
• Lr wheel spd sens -
• Pnk
• Power (battery)
• Power distribution center
• Red
• Rf wheel spd sens +
• Rf wheel spd sens -
• Right front wheel speed sensor (on right front steering knuckle)
• Right rear wheel speed sensor (on right end of rear axle)
• Rr wheel spd sens +
• Rr wheel spd sens -
• S13
• S132
• S134 (left rear of engine compt)
• S139 (left rear of engine compartment)
• S216
• Sci transmit
• Sensor test signal
• Stop lamp switch (top of brake pedal arm)
• Stop lmp sw out