ANTI-LOCK BRAKES – Jeep Liberty Sport 2003 – SYSTEM WIRING DIAGRAMS

ANTI-LOCK BRAKES

Anti-lock Brakes Wiring Diagram for Jeep Liberty Sport 2003

List of elements for Anti-lock Brakes Wiring Diagram for Jeep Liberty Sport 2003:

• (near breakout to left dash light)
• (not used)
• A10
• A20
• Abs warning ind control
• Abs warning indicator
• B12
• Body control module (integral with junction block)
• Brake lamp sw
• Brake lamp switch (above brake pedal, on bracket)
• Controller anti-lock brake (left rear of engine compt)
• D24
• D25
• Data link connector (behind left center of dash)
• F22
• Flash abs
• Fuse 10a
• Fuse 15a
• Fuse 20a
• Fuse 40a
• Fuse b (+)
• Fuse ign sw (run)
• G110 (left side of engine compt)
• Ground
• Hot at all times
• Hot in run
• Instrument cluster
• Jucntion block (below left end of dash)
• L50
• Left front wheel speed sensor (left side of engine compartment)
• Lf whl spd 12v
• Lf whl spd sig
• Pci bus
• Pnk
• Power distribution center (on left side of eng compt)
• Rear wheel speed sensor (on rear axle)
• Rear whl spd 12v
• Rear whl spd sig
• Red
• Rf whl spd 12v
• Rf whl spd sig
• Right front wheel speed sensor (right side of engine compartment)
• S201
• S207 (in breakout to c100)
• Vehicle speed sig
• Z101
• Z102