ANTI-LOCK BRAKES – Jeep Wrangler Rubicon 2005 – SYSTEM WIRING DIAGRAMS

ANTI-LOCK BRAKES

Anti-lock Brakes Wiring Diagram for Jeep Wrangler Rubicon 2005

List of elements for Anti-lock Brakes Wiring Diagram for Jeep Wrangler Rubicon 2005:

• (bottom left end of dash) data link connector
• A107
• A111
• Abs
• Abs system rly ctrl
• Abs warning ind
• Anti-lock brake relay (in power distribution center)
• B10
• Brake lamp sw out
• Brake lamp switch (on bracket, above brake pedal)
• Compt) s170
• Controller anti-lock brake (at left rear corner of engine compt)
• D21
• Except abs
• F102
• Fuse 10a
• Fuse 20a
• Fuse 30a
• Fuse 40a
• Fuse b (+)
• Fuse block (under right center of dash)
• Fused ign (run)
• G sw sensor 1
• G sw sensor 2
• G sw test signal
• G-switch (near breakout for controller anti-lock brake)
• G100 (on left center of firewall)
• G101 (on center of firewall)
• G117
• G118
• G119
• G83
• Ground
• Hot at all times
• Hot in run
• Hot in run or start
• Instrument cluster
• L50
• Left front wheel speed sensor (left side of engine compt)
• Left rear wheel speed sensor (near vehicle speed sensor breakout)
• Lf wheel spd sens +
• Lf wheel spd sens -
• Lr wheel spd sens +
• Lr wheel spd sens -
• Power distribution center (on right side of engine compt)
• Powertrain control module (right rear of engine compartment)
• Rf wheel spd sens +
• Rf wheel spd sens -
• Right front wheel speed sensor (right side of engine compt)
• Right rear wheel speed sensor (near vehicle speed sensor breakout)
• Rr wheel spd sens +
• Rr wheel spd sens -
• S106
• S108
• S215 (compass temperature mirror)
• S315 (left side of dash)
• Sci transmit
• Sci transmit c1
• Tan/red
• Z107
• Z127