ANTI-THEFT – Buick LeSabre Custom 1999 – SYSTEM WIRING DIAGRAMS

ANTI-THEFT

Forced Entry Wiring Diagram for Buick LeSabre Custom 1999

List of elements for Forced Entry Wiring Diagram for Buick LeSabre Custom 1999:

• (body harn, 14 cm from lamp control module conn breakout) s248
• (body harn, 31.5 cm from top edge of left kick wall channel)
• (body harn, 42.5 cm from remote function actuator module breakout)
• (body harn, 9 cm from left edge of dash harness channel)
• (buick) (pont)
• (i/p harn, buick: 5 cm from breakout to 116-pin conn below center of dash; pontiac: 12 cm from dash compt lamp breakout)
• (left kick panel)
• (others) (buick)
• B12
• Battery
• Body control module (near rear of glove box)
• Buick
• C b
• D b
• Data line
• Data link connector (dlc) (under left side of dash)
• Door lock input
• Door unlock input
• Door unlock input/output
• E10
• E11
• E12
• E13
• E16
• Exterior lamp input
• F10
• F13
• F16
• G200
• G200 (left kick panel)
• Ground
• Headlamps alarm output
• Horn relay control
• Horns system (horn relay)
• Hot at all times
• Indicator control
• Junction connector sp340 (left front door sill)
• Key unlock input
• Lamp control module (center of dash)
• Left front power door lock
• Left front door lock actuator
• Left front door lock cylinder switch
• Left front door open in
• Left rear door
• Lock actuator
• Lock switch
• Pass key circuit
• Passenger door jamb
• Passenger door open input
• Pontiac
• Rac/trunk rel fuse 2 15a
• Rear compartment lid tamper switch (near latch)
• Remote function actuator module (behind right
• Right front power door lock
• Right front door lock actuator
• Right front door lock cylinder switch
• Right i/p fuse block
• Right rear door lock actuator
• S210
• S218
• S225
• S251
• S252 (body harn, 20.5 cm from lamp control module breakout)
• S278
• S289
• S291
• S310 (body harn, 9 cm from breakout to ground at right kick panel)
• S603
• Side of dash)
• Tamper switch (buick)
• Tamper switch input
• Unlock
• Unlock switch

Pass-Key Wiring Diagram for Buick LeSabre Custom 1999

List of elements for Pass-Key Wiring Diagram for Buick LeSabre Custom 1999:

• (buick & pontiac w/ ua6)
• (olds)
• (olds) (pontiac & buick)
• (others)
• Accy
• Air bag/ vats fuse 2e 10a
• Bat
• Bulb test
• C202
• Deterrent relay (under left side of dash above i/p fuse block)
• E12
• E13
• Enable out
• Fuel enable
• G111 (near battery)
• Ground
• Hot at all times
• Hot in run
• Hot in run or start
• Hot in start
• I/p fuse block
• Ign
• Ignition key
• Ignition key lock cylinder
• Ignition switch
• Ind cntrl
• Ind control
• Instrument cluster (except buick w/ ub3)
• Key res feed
• Key res ret
• Lock
• Misc/rdo/ clstr fuse 9c (buick & pontiac) 10a
• Nca
• Off
• Or start
• Park/ neutral position switch (rear of transaxle, below egr valve)
• Pcm fuse 8 (olds)
• Pcm/ vats fuse 4 20a
• Pnk
• Powertrain control module (near air cleaner housing)
• Red
• Remote function actuator module (near rear of glove box)
• Remote indicator bank (buick w/ ub3)
• Resistor pellet
• Right underhood fuse block (center rear of engine compt)
• Rly cntrl
• Run
• S217
• S233 s207
• S266 (body harn, 37 cm from remote function actuator breakout)
• S270
• Security indicator
• Start
• Starter solenoid
• Theft
• Theft deterrent module (behind right side of dash)
• Vats fuse 1a 10a