ANTI-THEFT – Buick Regal GS 2004 – SYSTEM WIRING DIAGRAMS

ANTI-THEFT

Anti-theft Wiring Diagram for Buick Regal GS 2004

List of elements for Anti-theft Wiring Diagram for Buick Regal GS 2004:

• B10
• B12
• Batt
• Bcm gnd
• Bcm pwr fuse 10a
• Body control module (bcm) (behind left side of dash, left of steering column)
• Cluster fuse 10a
• Crank fuse 2 40a
• Crank relay ii
• Crank signal bcm, cluster fuse 10a
• Crank voltage
• Data link connector (dlc) (under left side of dash, right of steering column)
• F10
• G203 (below dash, right side of steering column)
• Hot at all times
• Hot in run or start
• Hot in run, bulb test or start
• Hot in start
• Hot in unlock, run or start
• I/p fuse block (behind right side of dash, in right door opening)
• Ign
• Ign 0
• Ign 0: cluster pcm & bcm fuse 10a
• Ign key sig
• Ign ref lo
• Ignition lock cylinder
• Ignition switch
• Instrument panel cluster
• K10
• K11
• Key
• Key in
• Key in sig
• Key out
• Logic
• M10
• M11
• Passkey ii system
• Pcm bcm u/h fuse 10a
• Pnk
• Powertrain control module (pcm) (left front side of engine compt, in air cleaner assembly)
• Resistor pellet
• S211
• S234
• S270
• Security ind
• Serial data
• Sp205 (behind data link connector)
• Starter (3.1l (vin j): left side of engine) (3.8l (vin k): lower front of engine compt)
• Starter rly ctrl
• Tan
• Underhood fuse block (mounted to right front strut tower)