ANTI-THEFT
Anti-theft Wiring Diagram for Chrysler PT Cruiser Limited 2004
List of elements for Anti-theft Wiring Diagram for Chrysler PT Cruiser Limited 2004:
- (near breakout for instrument cluster) s237
- D25
- Data link connector (under left side of dash, near kick panel)
- Door lk rl out
- Door locks system
- Door unlk rl out
- Driver door ajar
- Driver door power lock motor/ ajar switch (in driver's door)
- Driver dr lk
- Driver dr unlk
- F35
- Fuse 10a
- Fuse 20a
- Fuse block (at lower left front of dash)
- Fused b(+)
- Fused ig sw out
- Fused ign sw out
- G200 (behind center of dash)
- G201 (behind center of dash)
- G203 (behind center of dash)
- G300 (at left rear quarterpanel)
- G69
- G75
- G78
- Ground
- Headlights, exterior lights systems
- Horn relay
- Horns system
- Hot at all times
- Hot in run or start
- Indicator drivers
- Instrument cluster (left side of instrument panel)
- L4 (or l63)
- Left rear door ajar switch (above left rear wheelwell)
- Lf door sw mux
- Liftgate ajar sw
- Liftgate ajar switch (inside lower center of liftgate)
- Liftgate ajar switch sensor
- P33
- P34
- P35
- P36
- P96
- P97
- Pass door ajar
- Passenger door power lock motor/ ajar switch (in passenger door)
- Pci bus
- Pnk
- R door sw mux
- Red
- Remote keyless entry module (behind upper center of dash)
- Right rear door ajar switch (above right rear wheelwell)
- S201 (near breakout for brake shift interlock solenoid)
- S220
- S224
- S235 (near breakout for passenger air bag)
- S239
- S309
- S310
- S311
- Sentry key immobilizer module (on steering column, near ignition lock cylinder)
- Tan
- Tan/red
- Vtss ind
- W/ rke