Buick Skylark 1991 - FUSES & CIRCUIT BREAKERS 1985-93 FUSES & CIRCUIT BREAKERS General Motors

Buick Skylark 1991 - FUSES & CIRCUIT BREAKERS

Wiring circuits in vehicle are protected from short circuits by a combination of fuses, circuit breakers and fusible thermal links. This greatly reduces the chance of fires should an electrical overload occur. The windshield wipers and headlight circuits are protected by circuit breakers. These systems may cycle on and off if a short occurs. Have systems inspected immediately to correct the cause of overloading.

Buick Skylark 1991 - FUSE PANEL IDENTIFICATION (1985-89 SKYLARK & SOMERSET)

Fig. 1: Buick Skylark 1991 - Component Locations - Fuse Panel Identification (1985-89 Skylark & Somerset)

1. 1 - 20 Amp Taillights
2. 2 - 25 Amp Windshield Wiper
3. 3 - 25 Amp (1985-88) Fuel Pump (4-Cylinder) Blank (1989)
4. 4 - 25 Amp Fuel Pump (V6)
5. 5 - 20 Amp Turn Signals, Back-Up Lights
6. 6 - 10 Amp Gauges
7. 7 - 20 Amp (1985-88) Engine Cooling Fan Blank (1989)
8. 8 - 25 Amp Heater, A/C
9. 9 - 10 Amp ECM & Ignition (1985-88 V6), ECM Relays (1989)
10. 10 - 10 Amp ECM (4-Cylinder)
11. 11 - 10 Amp (1985-88) Starter Motor Blank (1989)
12. 12 - 5 Amp Instrument Panel Lights
13. 13 - 20 Amp Stoplights, Hazard Lights
14. 14 - 10 Amp (1985-88) ECM Relay, Engine & Emission Control Relays Blank (1989-91)
15. 15 - 20 Amp Clock, Cigarette Lighter
16. 16 - 10 Amp Radio
17. 17 - 20 Amp Courtesy Lights

Buick Skylark 1991 - FUSE PANEL IDENTIFICATION (1990-91 SKYLARK)

Fig. 2: Buick Skylark 1991 - Component Locations - Fuse Panel Identification (1990-91 Skylark)

1. 1 - 20 Amp Front & Rear Marker Lights, Parking Lights, Taillights, License Lights, Instrument Panel, Interior Lights
2. 2 - 20 Amp Interior Lights, Luggage Compartment Light, Warning & Alarms/Chime
3. 3 - 10 Amp Cruise Control (4-Cylinder VIN D & V6 VIN N), Radio
4. 4 - 20 Amp Cigarette Lighter, Horns, Power Antenna, Power Door Locks
5. 5 - 20 Amp Turn Signals, Hazard Light, Stoplight
6. 6 - 20 Amp Multi-Port Fuel Injection, Ignition (4 Cylinder VIN D & V6 VIN N)
7. 7 - 5 Amp Interior Lights Dimming, Radio, Rear Window Defogger, Warning & Alarms/Chime
8. 8 - 10 Amp Air Conditioning, Anti-Lock Brakes (4-Cylinder), Cruise Control (4-Cylinder), Electronic Fuel Injection: Power (4-Cylinder VIN U), Multiport Fuel Injection: Power, Engine Data Sensors (V6 VIN N), Multiport Fuel Injection: Power (4-Cylinder VIN D), Starter & Charging System
9. 9 - 30 Amp Circuit Breaker Power Door Locks, Power Seats, Rear Window Defogger
10. 10 - 30 Amp Circuit Breaker Power Windows
11. 11 - 25 Amp Air Conditioning, Anti-Lock Brakes, Coolant Fan, Daytime Running Lights, Heater, Luggage Compartment Lid Release
12. 12 - 10 Amp Instrument Panel, Interior Lights, Rear Window Defogger, Warning & Alarms/Chime
13. 13 - 20 Amp Back-Up Lights, Turn Signals, Hazard Lights, Stoplights
14. 14 - 20 Amp Electronic Fuel Injection: Fuel Control & Injector (4-Cylinder VIN U), Multiport Fuel Injection: Fuel Control & Injectors (4-Cylinder VIN D, V6 VIN N)
15. 15 - 10 Amp Radio
16. 16 - 25 Amp Windshield Wiper/Washer

Buick Skylark 1991 - FUSE PANEL IDENTIFICATION (1992-93 SKYLARK)

Fig. 3: Buick Skylark 1991 - Component Locations - Fuse Panel Identification (1992-93 Skylark)

1. 1 - 10 Amp Back-Up Lights, Instrument Panel
2. 2 - 5 Amp Audible Warning/Chime, Interior Lights Dimming, Radio/Audio Systems, Rear Window Defogger, Ride Control
3. 3 - 10 Amp Cruise Control, Radio/Audio Systems
4. 4 - 25 Amp Windshield Wiper/Washer
5. 5 - 20 Amp Multiport Fuel Injection
6. 6 - 10 Amp Anti-Lock Brake, Audible Warnings/Chime, Brake Transaxle Shift Interlock (BTSI), Instrument Panel, Keyless Entry, Rear Window Defogger
7. 7 - 20 Amp Turn Signals, Hazard Lights, Stoplights
8. 8 - 20 Amp Automatic Door Locks, Cigarette Lighter, Instrument Panel, Interior Lights, Horn
9. 9 - 10 Amp Radio/Audio Systems
10. 10 - 15 Amp Audible Warnings/Chime, Interior Lights, Luggage Compartment Light, Power Mirrors
11. 11 - 5 Amp Keyless Entry
12. 12 - 25 Amp Anti-Lock Brake, Engine Vent Heater, Headlights, Daytime Running Lights, Heater, Ride Control
13. 13 - 30 Amp Circuit Breaker Power Windows
14. 14 - 30 Amp Circuit Breaker Automatic Door Locks, Keyless Entry, Power Antenna, Power Seats, Rear Window Defogger
15. 15 - 20 Amp Circuit Breaker Headlights, Daytime Running Lights
16. 16 - 20 Amp Headlights
17. 17 - 20 Amp Exterior Lights
18. 18 - 20 Amp Multiport Fuel Injection: Ignition
19. 19 - 15 Amp HVAC, Multiport Fuel Injection, Starter & Charging System
20. 20 - 20 Amp Exterior Lights

Buick Skylark 1991 - BATTERY SPECIFICATIONS

CAUTION:

When battery is disconnected, vehicles equipped with computers may lose memory data. When battery power is restored, driveability problems may exist on some vehicles. These vehicles may require a relearn procedure. See COMPUTER RELEARN PROCEDURES article in the GENERAL INFORMATION section.

All models use BCI group 75A batteries.

Buick Skylark 1991 - CAUTIONS & WARNINGS ANTI-LOCK BRAKE SYSTEM

The anti-lock brake system contains electronic equipment that can be susceptible to interference caused by improperly installed or high output radio transmitting equipment. Since this interference could cause the possible loss of the anti-lock braking capability, such equipment should be installed by qualified professionals.

On models equipped with anti-lock brake systems, ALWAYS observe the following cautions:

• DO NOT attempt to bleed hydraulic system without first referring to the appropriate ANTI-LOCK BRAKE SYSTEM article in the BRAKES Section.
• DO NOT mix tire sizes. As long as tires remain close to the original diameter, increasing the width is acceptable. Rolling diameter must be identical for all 4 tires. Some manufacturers recommend tires of the same brand, style and type. Failure to follow this precaution may cause inaccurate wheel speed readings.
• Use ONLY recommended brake fluids. DO NOT use silicone brake fluids in an ABS-equipped vehicle.

Buick Skylark 1991 - BATTERY WARNING

WARNING:

When battery is disconnected, vehicles equipped with computers may lose memory data. When battery power is restored, driveability problems may exist on some vehicles. These vehicles may require a relearn procedure. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION section.

Buick Skylark 1991 - REPLACING BLOWN FUSES

Before replacing a blown fuse, remove ignition key, turn off all lights and accessories to avoid damaging the electrical system. Be sure to use fuse with the correct indicated amperage rating. The use of an incorrect amperage rating fuse may result in a dangerous electrical system overload.

Buick Skylark 1991 - BRAKE PAD WEAR INDICATOR

Indicator will cause a squealing or scraping noise, warning that brake pads need replacement.

Buick Skylark 1991 - CATALYTIC CONVERTER

Continued operation of vehicle with a severe malfunction could cause converter to overheat, resulting in possible damage to converter and vehicle.

Buick Skylark 1991 - COOLANT (PROPYLENE-GLYCOL FORMULATIONS)

CAUTION:

To avoid possible damage to vehicle use only ethylene-glycol based coolants with a mixture ratio from 44-68% anti-freeze. DO NOT use 100% anti-freeze as it will cause the formation of cooling system deposits. This results in coolant temperatures of over 300? F (149?C) which can melt plastics. 100% anti-freeze has a freeze point of only -8? F (-22?C).

CAUTION:

Propylene-Glycol Mixtures has a smaller temperature range than Ethylene-Glycol. The temperature range (freeze-boil) of a 50/50 Anti-Freeze/Water Mix is as follows: Propylene-Glycol -26? F (-32?C) - 257? F (125?C) Ethylene-Glycol -35? F (-37?C) - 263? F (128?C)

CAUTION:

Propylene-Glycol/Ethylene-Glycol Mixtures can cause the destabilization of various corrosion inhibitors. Also Propylene-Glycol/Ethylene-Glycol has a different specific gravity than Ethylene-Glycol coolant, which will result in inaccurate freeze point calculations.

Buick Skylark 1991 - ELECTROSTATIC DISCHARGE SENSITIVE (ESD) PARTS

WARNING:

Many solid state electrical components can be damaged by static electricity (ESD). Some will display a warning label, but many will not. Discharge personal static electricity by touching a metal ground point on the vehicle prior to servicing any ESD sensitive component.

Buick Skylark 1991 - ENGINE OIL

CAUTION:

Never use non-detergent or straight mineral oil.

Buick Skylark 1991 - FUEL SYSTEM SERVICE

WARNING:

Relieve fuel system pressure prior to servicing any fuel system component (fuel injection models).

Buick Skylark 1991 - HALOGEN BULBS

WARNING:

Halogen bulbs contain pressurized gas which may explode if overheated. DO NOT touch glass portion of bulb with bare hands. Eye protection should be worn when handling or working around halogen bulbs.

Buick Skylark 1991 - RADIATOR CAP

CAUTION:

Always disconnect the fan motor when working near the radiator fan. The fan is temperature controlled and could start at any time even when the ignition key is in the OFF position. DO NOT loosen or remove radiator cap when cooling system is hot.

Buick Skylark 1991 - RADIATOR FAN

WARNING:

Keep hands away from radiator fan. Fan is controlled by a thermostatic switch which may come on or run for up to 15 minutes even after engine is turned off.