COMPUTER DATA LINES – Buick Allure CXL 2008 – SYSTEM WIRING DIAGRAMS

COMPUTER DATA LINES

Computer Data Lines Wiring Diagram for Buick Allure CXL 2008

List of elements for Computer Data Lines Wiring Diagram for Buick Allure CXL 2008:

• (base of steering column)
• (i/p wiring harness, approximately 4 cm from breakout to remote control door lock receiver)
• (left side of dash) g202
• 3.8l
• 5.3l
• A11
• Abs/tcs class 2 serial data
• Adg class 2 serial data
• B10
• Bcm class 2 serial data
• Body control module (bcm) (left side of dash)
• Class 2 serial data
• Data bus (+)
• Data bus (-)
• Data bus +
• Data bus -
• Data link connector (dlc) (left side of dash)
• Digital radio receiver (left side of trunk)
• Ecm class 2 serial data
• Electronic brake control module (ebcm) (integral to brake pressure modulator valve)
• Engine control module (ecm) (left front of engine compt)
• G200 (left side of dash)
• Hot at all times
• Hvac class 2 serial data
• Hvac control module (center of dash)
• I/p fuse block (right side of dash)
• If equipped
• Inflatable restraint sensing & diagnostic module (sdm) (under front passenger's seat)
• Instrument panel cluster (ipc)
• Ipc class 2 serial data
• J201 (i/p wiring harness, 4 cm from breakout to rcdlr)
• J202
• J211
• J213
• Manual a/c automatic a/c
• Nca
• Onstar/ aldl fuse 10a
• Pcm class 2 serial data
• Pnk
• Power distribution system
• Powertrain control module (pcm)
• Radio
• Radio class 2 serial data
• Remote control door lock receiver (rcdlr) (right side of dash)
• Rfa class 2 serial data
• Sdm class 2 serial data
• Splice pack jx205 (clipped to knee bolster panel, right of data link connector)
• Steering angle sensor (w/ active brake control)
• Tan
• Terminator resistor
• Throttle actuator control (tac) module (3.8l) (at throttle body)
• Transmission control module (tcm) (left front of engine compt)
• Uart serial data primary
• Uart serial data secondary
• Vehicle communication interface module (vcim) (center of dash)
• W/ onstar