COOLING FAN
Cooling Fan Wiring Diagram for Cadillac ATS 2013
List of elements for Cooling Fan Wiring Diagram for Cadillac ATS 2013:
- 3.6l
- 3.6l w/ engine oil
- Aos disply/ mil ign fuse 5a
- Auxiliary underhood fuse block (right front of engine compt)
- Batt + volt
- Computer data lines system
- Cooling fan control module (engine cooling fan assembly)
- Cooling fan fuse 60a
- Cooling fan motor
- Cooling system & 2.0l w/ extra capacity
- Cooling temp sens 2 lo ref
- Cooling temp sens 2 sig
- Ecm ign fuse 15a
- Eng cool ctrl
- Eng temp sens sig
- Engine control module (ecm) (right front of engine compt)
- Engine coolant temperature gauge
- Engine coolant temperature indicator
- Engine coolant temperature sensor (3.6l: near mechanical vacuum pump) (except 3.6l: in thermostat housing)
- Engine coolant temperature sensor 2 (2.5l)
- Engine coolant thermostat heater (2.5l) (front of engine)
- Except 3.6l
- Except 3.6l w/ engine oil cooling system & 2.0l w/ extra capacity
- Fuse 4 70a
- G102 (above right headlight)
- G107 (on front of right cylinder head)
- G201 (left kick panel)
- Gmlan serial data (+)
- Gmlan serial data (-)
- Gnd
- Ground
- Hot at all times
- Hot w/ engine controls ignition relay energized
- Hot w/ ignition main relay energized
- Ign 1 volt
- Ign coil inj fuse 15a
- Instrument cluster
- J132
- Logic
- Run/crank ignition 1 volt
- Sens lo ref
- Serial data
- Sig gnd
- Speed sig
- Speed signal
- Underhood fuse block (right front of engine compt)
- X126
- X150
- X275