CRUISE CONTROL – Buick Century Custom 2005 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Buick Century Custom 2005

List of elements for Cruise Control Wiring Diagram for Buick Century Custom 2005:

• (ashtray jumper wiring harness, inside ashtray, 5 cm from c242) s295
• Anti-lock brakes system
• B10
• Brake signal input
• Computer data lines system
• Cruise control module (ccm) (front of left strut tower)
• Cruise control on/off switch
• Cruise control release switch (under left side of dash, on brake pedal bracket)
• Cruise fuse 10a
• Cruise ind
• Cruise on/off
• Disable input
• Disable output
• Engage input
• Engaged output
• Exterior lights system
• G201 (below dash, left side of steering column)
• Ground
• Hot at all times
• Hot in run
• I/p fuse block (behind right side of dash, in right door opening)
• Ignition
• Instrument panel cluster (ipc)
• Logic
• Off
• Pnk
• Powertrain control module (pcm) (left front side of engine compt, in air cleaner assembly
• R/a
• Release signal
• Resume/accel
• S205 (i/p wiring harness, below dash, near c201, 14 cm from g201 breakout)
• S240
• S283
• Serial data
• Set sw
• Set/coast
• Stop lamp switch (on brake pedal support bracket)
• Stop lamps fuse 15a
• Turn signal/ multifunction switch (in steering column)
• Vehicle speed input
• Vehicle speed sensor (vss) (on transaxle right axle case extension)
• Vss
• Vss high
• Vss low
• Vss output