CRUISE CONTROL – Buick LeSabre Custom 2003 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Buick LeSabre Custom 2003

List of elements for Cruise Control Wiring Diagram for Buick LeSabre Custom 2003:

• Abs/tcc switch (near brake pedal)
• All times
• Cancel input
• Cr cont fuse 10a
• Cruise control module (on left side of engine compt, on strut tower)
• Cruise inhibit
• Cruise on/off
• Cruise set/coast
• Disable output
• Engage ouput
• Engaged input
• G106 (near left strut tower, on frame rail)
• Ground
• Hot at
• Hot in
• Ign 1 fuse 10a
• Ignition
• Inflatable restraint steering wheels module coil
• Left steering wheels controls
• Nca
• On & start
• On/off
• Pnk
• Powertrain control module (pcm) (in air cleaner housing)
• Rear fuse block (under left rear seat)
• Resume/ accel
• Resume/accel
• Right steering wheels controls
• S215 (body harness, left side of vehicle)
• S216
• S228
• Set/ coast
• Splice pack sp106
• Splice pack sp301 (under right front seat)
• Steering column fuse holder
• Stop lp fuse 15a
• Stoplamp switch (on brake pedal bracket)
• Stp lp sig input
• Transmission system
• Underhood fuse block (right front side of engine)
• Vehicle speed input
• Vehicle speed out
• Vehicle speed sensor (vss) (on right front of transaxle, below power steering pump)
• Vss high
• Vss low