CRUISE CONTROL – Buick LeSabre Limited 2004 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Buick LeSabre Limited 2004

List of elements for Cruise Control Wiring Diagram for Buick LeSabre Limited 2004:

• (in i/p harness, 23.5 cm from instrument cluster breakout) s201
• Cr cont fuse 10a
• Cruise control module (on left side of engine compt, on strut tower)
• Cruise control on sw
• Cruise ind
• Cruise inhibit
• Cruise on/off
• Cruise set/coast
• Disable output
• Engage ouput
• Engaged input
• G106 (near left strut tower)
• Ground
• Head up display (hud) (on top left side of dash)
• Hot at all times
• Hot in on or start
• Ign 1 fuse 10a
• Ignition
• Inflatable restraint steering wheels module coil (steering wheel)
• Instrument panel cluster (ipc)
• Left steering wheels controls
• Logic
• Nca
• On/off
• Pnk
• Powertrain control module (pcm) (in air cleaner housing)
• Rear fuse block (under left rear seat)
• Resume/ accel
• Resume/accel
• Right steering wheels controls
• S215 (in body harness, 19.5 cm from p100)
• S216
• S228
• Set/ coast
• Sp106
• Sp301 (in body harness, 8.5 cm from g300 breakout)
• Speed input
• Steering column fuse holder
• Stop lamp switch (on brake pedal bracket)
• Stop lp fuse 15a
• Stp lp sig input
• Transmissions system
• Underhood fuse block (right front side of engine compt)
• Vehicle speed input
• Vehicle speed out
• Vehicle speed sensor (vss) (on top right side of transmission output housing)
• Vehicle speed signal
• Vss high
• Vss low
• W/ head up display