CRUISE CONTROL – Buick Rendezvous CX 2007 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Buick Rendezvous CX 2007

List of elements for Cruise Control Wiring Diagram for Buick Rendezvous CX 2007:

• (engine harness, 3 cm from c103, toward c175) s117
• (left side of engine compt)
• (not used)
• 5 volt ref
• 5 volt reference
• A2 c1
• Accelerator pedal position (app) sensor (above accelerator pedal)
• All times
• App sensor 1 sig
• App sensor 2 sig
• Bat
• Body control module (bcm) (in console, above fuse block, in center console)
• C103
• Center console fuse block (in center console)
• Class 2 serial data
• Computer data lines system
• Cruise ctrl on switch sig
• Cruise fuse 10a
• Cruise indicator
• Electronic brake control module (ebcm)
• F11
• G117 (engine compt, on bell housing, above starter)
• Ground
• Hazrd lamp fuse 40 15a
• Hot at
• Hot in run or start
• Hot w/ ptrain relay energized
• Ign
• Ignition 1
• Instrument panel cluster (ipc)
• Ipc class 2 serial data
• Logic
• Low reference
• Off
• Pnk
• Powertrain control module (pcm) (at left side of engine compt, in air cleaner assembly)
• Pt rly fuse 15a
• R/a
• Radio (if equipped)
• Rear parking assist (rpa) module (if equipped) (behind left rear interior trim panel)
• Resume/accel sw sig
• S106
• S141
• S209 (i/p harness, left side of dash, 4 cm before breakout to main pass-thru)
• Serial data (pri)
• Serial data (sec)
• Set sw
• Set/coast sw sig
• Stop lamp sw sig
• Stop lamp switch
• Stop lamp switch (on brake pedal support)
• Tan
• Tcc brake switch
• Tcc brake switch sig
• Throttle actuator control (tac) module
• Trn sig flshr/hazrd flshr module 10
• Turn signal/ multifunction switch
• Uart serial data (primary)
• Uart serial data (secondary)
• Underhood fuse block (front of right wheel well, above battery)
• Vehicle speed sensor (vss) (on transmission)
• Vehicle speed sig
• Vss high signal
• Vss low signal