CRUISE CONTROL
Cruise Control Wiring Diagram for Cadillac SRX 2008
List of elements for Cruise Control Wiring Diagram for Cadillac SRX 2008:
- (in steering column harness, 30 cm from x202) j208
- (on right rear of engine,on cylinder head) g100
- (on top right side engine manifold block) g106
- (or 1550)
- 12v ref
- 3.6l
- 3.6l 4.6l
- 4.6l
- 5v ref
- 5v ref 1
- 5v ref 2
- 5v ref 3
- Accelerator pedal
- Air bag fuse 10a
- App sens 1 sig
- App sens 2 sig
- Automatic transmission (5 speed)
- Automatic transmission (6 speed)
- Bcm 2 fuse 10a
- Body control module (bcm) (on lower left side of dash)
- Brake pedal position (bpp) sensor (near top of brake pedal)
- Cancel
- Computer
- Computer data lines system
- Control solenoid valve assembly
- Cruise ctrl sw sig
- Cruise ind
- Cruise switch
- Data lines
- Ecm batt fuse 15a
- Engine control module (ecm) (3.6l: mounted on engine right valve cover) (4.6l: on left front frame rail, under left headlight assembly)
- F20
- F21
- F32
- F33
- G104 (right body rail, behind washer reservoir)
- Gnd
- Hi spd data bus+
- Hi spd data bus-
- Hi spd gmlan bus+
- Hi spd gmlan bus-
- Hot at all times
- Ign relay
- Ign volt
- Ignition
- Inflatable restraint steering wheel module coil (behind steering wheel)
- Input speed sensor (iss)
- Instrument panel cluster (ipc)
- J115
- Left steering wheel control switch
- Lo ref
- Logic
- Low ref
- Low spd serial data
- Nca
- Output speed sensor (oss)
- Pnk
- Position (app) sensor (above accelerator pedal)
- Red
- Reset+
- Seats system
- Serial data (ecm)
- Set-
- Sound systems
- Stop lamp sw sig
- System
- Tac motor ctrl 1
- Tac motor ctrl 2
- Tan
- Throttle actuator control (tac) module (3.6l: at top front of engine) (4.6l: at front of engine)
- Throttle actuator control (tac) motor
- Throttle position (tp) sensor
- Tp sens 1 sig
- Tp sens 2 sig
- Transmission control module
- Transmission control module (5 speed)
- Transmissions system
- Underhood fuse block (at right front of engine compt)
- X208