CRUISE CONTROL
Adaptive Cruise Control Wiring Diagram for Cadillac STS V 2007
https://portal-diagnostov.com/license.html
https://portal-diagnostov.com/license.html
Automotive Electricians Portal FZCO
Automotive Electricians Portal FZCO List of elements for Adaptive Cruise Control Wiring Diagram for Cadillac STS V 2007:
- (below right "c" pillar) electronic suspension control (esc) module
- (in forward lamp harness, 31 cm from right headlamp leveling actuator connector) s116
- (on dash harness, under dashboard, near firewall grommet) sp201
- 5v ref
- A11
- Alert distance cruise speed limited follow distance set speed set xx mph tight curve
- Brake pedal position sensor (attached to top of brake pedal assembly)
- C276
- C277
- Ccp fuse 10a
- Clean radar cruise cruise disengage cruise not ready cruise set xx mph service radar cruise
- Computer data lines system
- Cruise control switch
- Distance sensing cruise control module (behind front fascia, near hood latch)
- Electronic brake control module (ebcm) (on right front corner of engine compt, behind right front wheel)
- Fuse 2a
- Fuse block steering column fuse box or holder
- G104 (on right front frame rail, near bumper bracket)
- Gmlan serial wake up
- Gmlan serial data bus +
- Gmlan serial data bus -
- Gmlan serial wake up
- Ground
- Head up display (hud)
- Headlights system
- Hot at all times
- Ignition 1 voltage
- Inflatable restraint steering wheel module coil (top of steering column, behind steering wheel)
- Instrument panel cluster (ipc)
- Instrument panel module (ipm) (right side of dash, behind glove box)
- Left steering wheel controls
- Logic
- Low ref
- Message center
- Message request
- Nca
- Off
- Pnk
- Power distribution system
- Resume/ accel +
- Right steering wheel controls
- S229 (in steering column harness)
- Sens sig
- Serial data
- Serial data +
- Serial data -
- Set/ coast
- Signal
- Tan
- Turn signal/ multifunction switch
- Underhood fuse block (right front side of engine compt)
- W/ hid lamps
Conventional Cruise Control Wiring Diagram for Cadillac STS V 2007
List of elements for Conventional Cruise Control Wiring Diagram for Cadillac STS V 2007:
- (near left front strut tower, at bottom of inside fender well) g101
- 3.6l
- 4.4l
- 4.6l
- 4.6l & 4.4l
- 5 volt reference
- 5 volt reference 1
- 5 volt reference 2
- Accelerator pedal position (app) sensor (attached to top of accelerator pedal)
- Alert distance cruise speed limited follow distance set speed set xx mph tight curve
- App sensor 1 signal
- App sensor 2 signal
- Brake pedal position sensor (attached to top of brake pedal assembly)
- Clean radar cruise cruise disengage cruise not ready cruise set xx mph service radar cruise
- Coast
- Computer data lines system
- Cruise control switch
- Cruise ind
- Engine control module (ecm) (3.6l: front of engine, on right valve cover) (4.6l & 4.4l: on left front frame rail, below left headlamp assembly)
- Exterior lights system
- Fuse 2a
- Fuse block steering column fuse box or holder
- Gmlan (ecm)
- Gmlan serial data
- Gnd
- Head up display (hud)
- Hot w/ run/crank relay energized
- Hud message center
- Ignition
- Instrument panel cluster (ipc)
- Instrument panel module (ipm) (right side of dash, behind glove box)
- Logic
- Low reference
- Message center
- Message request
- Off
- Pnk
- Resume/ accel+
- S147 (3.6l: 387 cm from c102) (4.6l: 24 cm from c102)
- S225 (in steering column harness)
- Serial data bus +
- Serial data bus -
- Set/
- Set/coast & resume/accelerate sw sig
- Sound systems
- Tac motor control-1
- Tac motor control-2
- Tan
- Tcc/cruise control release sig
- Tcm/ ipc fuse 15a
- Throttle actuator control (tac) motor
- Throttle body assembly
- Throttle position (tp) sensor
- Tp sensor 1 signal
- Tp sensor 2 signal
- Transmission control module (tcm)
- Turn signal/ multifunction switch
- Underhood fuse block (right front side of engine compt)