CRUISE CONTROL – Chevrolet Equinox LT 2007 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Chevrolet Equinox LT 2007

List of elements for Cruise Control Wiring Diagram for Chevrolet Equinox LT 2007:

• (not used)
• 5v ref
• 5v ref 2
• Accelerator pedal position (app) sensor (on accelerator pedal linkage arm)
• Air bag display fuse 10a
• App sen 1 sig
• App sen 2 sig
• Bat pos volt
• Bat pos vot
• Beneath right side of radio)
• Body control module (bcm) (center of dash, behind hvac control module)
• Brake pedal pos sens sig
• Brake pedal position sensor (on brake pedal assembly)
• C276
• C277
• Cancel
• Chevrolet
• Computer data lines system
• Control
• Corner of
• Cruise control ind dimming sig
• Cruise control switch signal
• Cruise ind
• Cruise switch
• Ecm batt fuse 15a
• Engine compt)
• Engine control module (ecm) (mounted on top of battery cover)
• G111 (rear of engine, near crankshaft sensor)
• G201 (behind right front kick panel)
• Ground
• Hi spd gmlan ser data bus+
• Hi spd gmlan ser data bus-
• Hot at all times
• Hot w/ ign 1 relay energized
• I/p fuse block (center of dash, c1
• Inflatable restraint steering wheel module coil (at top of steering column, behind steering wheel)
• Instrument panel cluster (ipc)
• Left steering wheel controls switch
• Logic
• Low ref
• Module (tcm) (at left rear
• Oss high sig
• Oss low sig
• Output shaft speed sensor (oss)
• Pnk
• Pontiac
• Red
• Res+
• Rvc fuse 10a
• S100
• Ser data
• Ser data bus+
• Ser data bus-
• Set-
• Sound systems
• Steering wheel cntrl sup volt
• Stop lamp sw sig
• Tac motor ctrl 1
• Tac motor ctrl 2
• Tan
• Throttle actuator control (tac) module (attached to throttle body)
• Tp sens 1 sig
• Tp sens 2 sig
• Transmission
• Underhood fuse block (left side of engine compt)