CRUISE CONTROL – Chevrolet Impala 2001 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Chevrolet Impala 2001

List of elements for Cruise Control Wiring Diagram for Chevrolet Impala 2001:

• A/c cruise fuse 10a
• All times
• Anti-lock brakes system
• B11
• Body control module (behind left side of dash)
• Brake sig input
• Brk sw fuse 15a
• C11
• Cruise control module (on left strut tower)
• Cruise control on/off switch
• Cruise control release switch (on brake pedal support)
• Cruise fuse 2a
• Cruise inhibit
• Cruise on/off
• Cruise release sig
• Cruise set/coast
• Disable output
• Engage ouput
• Engaged input
• Exterior lights system
• G114 (lower left rear of engine, on transaxle stud)
• Ground
• Hot at
• Hot in run
• Ignition
• Inflatable restraint steering wheels module coil
• Left i/p junction block
• Left steering wheel controls
• Nca
• Powertrain control module (pcm) (in air cleaner box)
• Resume/ accel
• Resume/accel
• Right i/p junction block
• Right steering wheel controls
• S106
• S217 (i/p harness, approx 7.5 cm from the breakout for the body control module)
• Set/ coast
• Stoplamp switch (on brake pedal support)
• Turn signal/ multi-function switch
• Vehicle speed input
• Vehicle speed out
• Vehicle speed sensor (vss) (right rear of engine compt, end of transaxle)
• Vss high
• Vss low