CRUISE CONTROL – Chevrolet Impala LS 2006 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram (1 of 2) for Chevrolet Impala LS 2006

List of elements for Cruise Control Wiring Diagram (1 of 2) for Chevrolet Impala LS 2006:

• (except 5.3l: on transmission to engine bolt, above starter) (5.3l: on transmission to engine bolt, below starter) g111
• 5 volt ref
• 5 volt ref 1
• 5 volt ref 2
• 5.3l
• Body control module (bcm) (left of steering column)
• Brake pedal position sensor (right side of brake pedal bracket)
• C275
• C277
• Computer data lines system
• Cruise ctrl ind sig
• Cruise ctrl sw sig
• Cruise ind
• Ecm ign fuse 10a
• Engine control module (ecm) (inside air cleaner assembly)
• Except 5.3l
• Gnd
• Hot at all times
• Ign
• Ign 1 voltage
• Inflatable restraint steering wheel module coil (in steering column behind steering wheel)
• Instrument panel cluster (ipc)
• Logic
• Low ref
• Nca
• Pnk
• S105 (in engine wiring harness, approximately 5.5 cm (2.25 in) from breakout to starter)
• Sens 1 sig
• Sens 2 sig
• Serial data
• Serial data +
• Serial data -
• Sply voltage
• Steering ctrl sig
• Stop lamp sw sig
• Tac motor ctrl 1
• Tac motor ctrl 2
• Tan
• Tp sensor 1 sig
• Tp sensor 2 sig
• Underhood fuse block (mounted to right strut tower)
• Vehicle speed sig

Cruise Control Wiring Diagram (2 of 2) for Chevrolet Impala LS 2006

List of elements for Cruise Control Wiring Diagram (2 of 2) for Chevrolet Impala LS 2006:

• 5.3l
• Accelerator pedal position (app) sensor (above accelerator pedal)
• Cruise on ind
• Except 5.3l
• Front sig high
• Front sig low
• Left steering wheel controls
• Right steering wheel controls
• S213 (on steering wheel harness, behind inflatable restraint steering wheel module)
• Stop lamp sw sig
• Tan
• Throttle body
• Transmission control module (tcm) (left side of engine compt in with air cleaner)
• Vehicle speed sensor (vss) (right side of transaxle, near right axle shaft)
• Vehicle speed sig
• W/ steering wheel
• W/o steering wheel