CRUISE CONTROL – Chevrolet Malibu LS 2012 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Chevrolet Malibu LS 2012

List of elements for Cruise Control Wiring Diagram for Chevrolet Malibu LS 2012:

• (top of steering column) inflatable restraint steering wheel module coil
• 2.4l (vin b)
• 3.6l
• 5 volt ref 1
• 5 volt ref 2
• 5v ref
• Accelerator pedal position sensor (app) (left side of dash)
• App sens 1 sig
• App sens 2 sig
• Automatic transmission
• Automatic transmission input shaft speed (iss) sensor
• Automatic transmission output shaft speed (oss) sensor
• Body control module (bcm) (under center console)
• Brake pedal position sensor (left side of dash)
• Brk pos sens sig
• Cluster/theft fuse 10a
• Computer data lines system
• Control solenoid valve assembly
• Cruise control switch signal
• Cruise indicator
• Cruise on ind
• Cruise on/off switch
• D12
• Engine control module (ecm) (2.4l ho & 3.6l: left front of engine compt)
• Except 3.6l
• G201 (under center console)
• Gmlan
• Gmlan serial data bus+
• Gmlan serial data bus-
• Gnd
• Hot at all times
• Hot w/ run/crank relay 32 energized
• Ibcm (run/ crank) fuse 21 30a
• Ibcm 1 fuse 20 30a
• Ign
• Instrument panel cluster (ipc)
• J201 (behind inflatable restraint wheel module)
• Left side of engine compt)
• Left steering wheel control switch
• Logic
• Low ref
• Low speed gmlan serial data
• Pnk
• Power distribution system
• Res +
• Run/crank fuse 2a
• Serial data
• Set -
• Stoplamp sw
• Stoplamp sw sig
• Tac motor ctrl 1
• Tac motor ctrl 2
• Tan
• Tap sens 1 sig
• Tap sens 2 sig
• Throttle body (front center of engine compartment)
• Transmission control module (tcm)
• Underhood fuse block (2.4l ho & 3.6l:
• Underhood fuse block (left side of engine compt)
• X206