CRUISE CONTROL – Chevrolet Malibu Maxx LT 2006 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Chevrolet Malibu Maxx LT 2006

List of elements for Cruise Control Wiring Diagram for Chevrolet Malibu Maxx LT 2006:

• (3.5l) c1
• (3.9l) c3
• (on transmission) vehicle speed sensor (vss)
• 3 spoke
• 3.5l
• 3.9l
• 4 spoke
• 5 volt reference
• Body control module (bcm) (below right side of dash, near blower motor)
• Brake pedal position sens sig
• Brake pedal position sensor (on brake pedal support)
• C1 (2.2l)
• C2 d3
• Cancel switch
• Computer data lines system
• Cruise control cancel signal
• Cruise control switch signal
• Cruise indicator
• Cruise on/off switch
• G201 (center console, front of body control module)
• Gmlan
• Ground
• High sig
• High sig vss
• Hot at all times
• Hot w/ run/crank relay energized
• Ibcm (r/c) fuse 21 30a
• Ibcm 2 fuse 25 50a
• Ign
• Inflatable restraint steering wheel module coil
• Instrument panel cluster
• Interior lights fuse 10a
• Left steering wheel controls
• Logic
• Low reference
• Low sig
• Low sig vss
• Low speed gmlan serial data
• Pnk
• Powertrain control module (pcm) (2.2l & 3.5l) engine control module (3.9l) (2.2l & 3.5l: front of battery)
• Resume switch
• Run/crank fuse 2a
• S201
• Serial data
• Set switch
• Stop lamp switch signal
• Stp sig
• Sw sig
• Sw sig stop lamp
• Switch signal
• Tan
• Throttle actuator control (tac) module (on throttle body)
• Transmission control module
• Underhood fuse block (on left side of engine compartment)
• Vehicle speed sensor (vss) (3.9l) (on transmission)