CRUISE CONTROL – Chevrolet Traverse LT 2012 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Chevrolet Traverse LT 2012

List of elements for Cruise Control Wiring Diagram for Chevrolet Traverse LT 2012:

• (in steering column harness, near base of steering column) j293
• (in steering wheel harness, near sir coil) (w/ steering wheel control) j291
• (top of steering column, below steering wheel) inflatable restraint steering wheel module coil
• +5v
• 12-volt reference
• 5v ref
• 5v ref 2
• 5v ref 3
• Accelerator pedal position (app) sensor (above accelerator pedal)
• Air bag fuse 10a
• All times
• App sen sig 1
• App sen sig 2
• Automatic transmission
• Body control module (bcm) (under left side of dash)
• Brake pedal position sensor (top of brake pedal assembly)
• Cancel
• Computer data lines system
• Control solenoid valve assembly
• Cruise cntrl ind
• Cruise cntrl sw sig
• Cruise ind
• Cruise switch
• Driver information center (dic) display
• Ecm fuse 15a
• Engine control module (ecm) (left side of engine)
• Exterior lights system
• G110 (right front of engine, mounted to cylinder head)
• G301 (behind left kick panel)
• Gmlan ser data bus+
• Gmlan ser data bus-
• Gmlan serial data
• Gnd
• Ground
• Hot at
• Hot w/ ignition main relay energized
• I/p fuse block (behind right end of dash) x2
• Ign
• Instrument panel cluster (ipc)
• J215
• Left steering wheel control switch
• Logic
• Low ref
• Output shaft speed (oss) sensor
• Pnk
• Reset+
• Set-
• Sound systems
• Stop lamp sup volt
• Stop lamp sw sig
• Tac motor ctrl 1
• Tac motor ctrl 2
• Tan
• Td sens sig 2
• Throttle body (top rear of engine)
• Tp sen sig 1
• Transmission control module
• Transmissions & sound systems
• Underhood fuse block (above right front wheelwell)
• X111
• X201