CRUISE CONTROL – Chrysler PT Cruiser Limited 2005 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Chrysler PT Cruiser Limited 2005

List of elements for Cruise Control Wiring Diagram for Chrysler PT Cruiser Limited 2005:

• (2.4l turbo)
• (2.4l)
• (a/t)
• (door traction cruise set)
• (m/t)
• (near breakout for c103, at left
• (near breakout for c212)
• (near breakout for camshaft position sensor)
• Brake lamp switch (on brake pedal bracket)
• Cancel
• Clockspring (bottom of steering wheel)
• Clutch pedal position switch (up) (on clutch/brake pedal bracket)
• Computer data lines system
• Cruise on/off
• D15
• D20
• D21
• D25
• Data link connector (under left side of dash, near kick panel)
• Dump
• Fuse 10 10a
• Fuse block (at lower left front of dash)
• Fused ignition
• G104 (at front of right front fender)
• Ground
• Hot in run or start
• Indicator drivers
• Input speed sens sig
• Input speed sensor (on left side of transaxle)
• Instrument cluster (left side of instrument panel)
• Interlock switch sig
• K167
• M/t a/t
• Output speed sens sig
• Output speed sensor (on left side of transaxle)
• Pci bus
• Pnk
• Powertrain control module (on firewall, behind power distribution center)
• Red/ tan
• Res/accel
• S107 s106 (near breakout for oxygen sensor 1/1 upstream) side of engine)
• S109
• S122 (near data link connector)
• S126 (near data link connector)
• S172 (at front of engine compartment)
• S201
• S224
• Sci receive (pcm)
• Sci receive (tcm)
• Sci transmit (pcm)
• Sci transmit (tcm)
• Sensor gnd
• Sensor sig
• Set/coast
• Speed control servo (at right rear corner of engine compt)
• Speed control switch
• Speed signal
• Speed sw sig
• T14
• T141
• T41
• T52
• Tan/red
• Transmission range sensor (in transaxle, on top of valve body)
• Trs t41 sns
• V32
• V35
• V36
• V37
• Vacuum
• Vacuum sol
• Vehicle speed sensor (m/t) (on transaxle)
• Vent
• Vent sol
• Vf display
• Vss input