CRUISE CONTROL
Cruise Control Wiring Diagram for Ford Expedition 1999
List of elements for Cruise Control Wiring Diagram for Ford Expedition 1999:
- (not used)
- Accel
- Air bag sliding contact (top of steering column)
- Battery junc- tion box
- Brake pedal position (bpp) switch (under left side of dash)
- Brake press in
- Brake pressure switch (left rear corner of engine compt)
- C234
- C242
- C243
- C257
- Central junction box
- Coast
- Control sw gnd
- Control sw in
- Fuse 15a
- Fuse 20a
- Fuse 5a
- G105 (rear of right fender apron)
- G200 (lower left kick panel)
- G203 (lower right kick panel)
- Ground
- Harn, near breakout to instrument cluster)
- Horn relay (in battery junction box)
- Horn switches
- Hot at all times
- Hot in run
- Ign
- Interior lights system
- Nca
- Off
- Ohms
- Oss sensor
- Output shaft speed (oss) sensor (on left side of transmission)
- Powertrain control module (on right side of engine compartment)
- Remote anti-theft personality (rap) module (behind left side of dash)
- Resume
- S102
- S112
- S138 (engine sensor harn, right rear of engine compt)
- S143 (engine sensor harn, near breakout to windshield wiper motor)
- S202
- Set/
- Signal return
- Speed control servo (in left side of engine compt)
- Speed control switch assembly
- Steering column assembly
- Vehicle speed input
- Vehicle speed out