CRUISE CONTROL – Ford Expedition 2002 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Ford Expedition 2002

List of elements for Cruise Control Wiring Diagram for Ford Expedition 2002:

• (not used)
• Accel
• Air bag sliding contact (top of steering column)
• Battery
• Battery junction box (on left side of eng compt)
• Brake pedal position (bpp) switch (under left side of dash)
• Brake press in
• Brake pressure switch (left rear corner of engine compt)
• C222
• C234
• C242
• C243
• C256
• C292
• Central junction box (under left side of dash)
• Central security module (behind left side of dash)
• Coast
• Control sw gnd
• Control sw in
• Expedition
• Fuse 15a
• Fuse 20a
• Fuse 5a
• G102 (rear of right fender apron)
• G200 (lower left kick panel)
• Ground
• Horn switch
• Horn switch in
• Hot at all times
• Hot in run
• Ign
• Navigator
• Nca
• Off
• Ohms
• Oss sensor
• Output shaft speed (oss) sensor (on left side of transmission)
• Powertrain control module (on right side of engine compartment)
• Resume
• S102
• S112
• S138 (engine sensor harn, right rear of engine compt)
• S143 (engine sensor harn, near breakout to windshield wiper motor)
• S208
• Set/
• Signal return
• Speed control servo (in left side of engine compt)
• Speed control switch assembly
• Steering column assembly
• Vehicle speed input
• Vehicle speed out