CRUISE CONTROL – GMC Acadia SLE 2013 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for GMC Acadia SLE 2013

List of elements for Cruise Control Wiring Diagram for GMC Acadia SLE 2013:

• (in steering column harness, near base of steering column) j293
• (in steering wheel harness, near sir coil) (w/ steering wheel control) j291
• 12-volt reference
• 5 volt ref 4
• 5v ref 2
• 5v ref 3
• Accelerator pedal position (app) sensor (above accelerator pedal)
• Air bag fuse 10a
• App sen sig 1
• App sen sig 2
• Automatic transmission assembly
• Body control module (bcm) (under left side of dash)
• Brake pedal position sensor (top of brake pedal assembly)
• Brk pos sen 5 volt ref
• Brk pos sen lo ref
• Brk pos sen sig
• Cancel
• Computer data lines system
• Control solenoid valve assembly
• Cruise cntrl ind
• Cruise cntrl sw sig
• Cruise ind
• Cruise switch
• Driver information center (dic) display
• Engine control module (ecm) (left side of engine)
• Exterior lights system
• G110 (right front of engine, mounted to cylinder head)
• G301 (behind left kick panel)
• Gmlan ser data bus+
• Gmlan ser data bus-
• Gmlan serial data
• Gnd
• Ground
• Hot at all times
• I/p fuse block (behind right end of dash) x2
• Ign
• Instrument panel cluster (ipc)
• J215
• Left steering wheel controls switch
• Logic
• Low ref
• Output shaft speed (oss) sensor
• Pcm ign fuse 10a
• Pnk
• Reset+
• Set-
• Sound systems
• Steering wheel air bag coil
• Stop lamp sup volt
• Tac motor ctrl 1
• Tac motor ctrl 2
• Tan
• Throttle body (top rear of engine)
• Throttle pos sen sig (1)
• Transmission control module
• Transmissions & sound systems
• Underhood fuse block (above right front wheelwell)
• X111
• X112
• X201