CRUISE CONTROL — GMC Acadia SLT 2007 — SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for GMC Acadia SLT 2007

List of elements for Cruise Control Wiring Diagram for GMC Acadia SLT 2007:

• (in steering column harness, near base of steering column) j293
• (in steering wheel harness, near sir coil) (w/ steering wheel control) j291
• (top of steering column, below steering wheel) inflatable restraint steering wheel module coil
• 5v ref
• Accelerator pedal position (app) sensor (above accelerator pedal)
• Air bag fuse 10a
• All times
• App sen 1 sig
• App sen 2 sig
• Body control module (bcm) (under left side of dash)
• Cancel
• Computer data lines system
• Cruise cntrl ind
• Cruise cntrl sw sig
• Cruise ind
• Cruise set to xxx
• Cruise switch
• Driver information center (ipc)
• Ecm fuse 15a
• Engine control module (ecm) (left front corner of engine compt)
• G110 (right front of engine, mounted to cylinder head)
• Glman ser data bus+
• Glman ser data bus-
• Gmlan ser data bus+
• Gmlan ser data bus-
• Gmlan serial data
• Ground
• Hot at
• Hot w/ ign relay energized
• I/p fuse block (behind right end of dash) x2
• Ign
• Instrument panel cluster (ipc)
• Left steering wheel control switch assembly
• Logic
• Low ref
• Pnk
• Re rad cntrl sup vot
• Reset+
• Set-
• Stop lamp sup volt
• Tac mot cntrl 1
• Tac mot cntrl 2
• Tan
• Throttle body (top rear of engine)
• Tp sen 1 sig
• Tp sen 2 sig
• Underhood fuse block (above right front wheelwell)