CRUISE CONTROL – GMC Canyon 2005 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for GMC Canyon 2005

List of elements for Cruise Control Wiring Diagram for GMC Canyon 2005:

• 5 volt reference
• Class 2 serial data
• Cluster fuse 38 10a
• Clutch switch (if equipped) (lower left side of dash)
• Coast
• Computer data lines system
• Cpp switch signal
• Cruise control switch
• Cruise fuse 19 10a
• Cruise indicator
• E11
• G105
• Hot at all times
• Hot in run or start
• Ignition
• Instrument panel cluster (ipc)
• Logic
• Low reference
• Pnk
• Power distribution system
• Powertrain control module (pcm) (right rear corner of engine compt)
• Resume/ accel
• Run/crank relay
• S100 (body harness, 14.5 cm from accelerator pedal position switch breakout)
• Set/
• Sp105 (left side of engine compt)
• Stop fuse 1 20a
• Stop lamp switch (above brake pedal assembly)
• Tac motor control-1
• Tac motor control-2
• Tcc brake switch/cruise control release signal
• Tcc brake/cruise release switch (above brake pedal assembly)
• Throttle actuator control (tac) motor
• Throttle body
• Throttle position (tp) sens 1
• Throttle position (tp) sens 2
• Tp sensor 1 signal
• Tp sensor 2 signal
• Turn signal/multifunction switch
• Underhood fuse block (on left front side of engine compartment)
• Vehicle speed sensor (vss) (on left rear of transfer case)
• Vss high signal
• Vss low signal