CRUISE CONTROL – GMC Sonoma 2001 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for GMC Sonoma 2001

List of elements for Cruise Control Wiring Diagram for GMC Sonoma 2001:

• (on left side of firewall)
• 2.2l
• 4.3l
• 4wd only
• A/t
• A12
• A13
• A14
• A15
• Abs fuse 22 10a
• Bare
• Body computer system
• Body relay block (behind left side of dash)
• Brake cutout 1
• Brake/clutch signal
• C116 (near top right rear of transmission)
• Clutch pedal position & cruise control
• Cruise control module
• Cruise fuse 3 10a
• Cruise on/off input
• Cruise status
• Cut-out switch (clutch pedal support bracket)
• Engine controls system (2.2l)
• Exterior lights system
• G104 (left rear of engine compt)
• G114 (left rear of engine)
• G117 (right rear of engine)
• Ground
• Hot in run
• I/p fuse block (left end of dash)
• Ignition
• Instrument cluster system
• M/t
• Multifunction switch
• Off
• Powertrain control module (right front of engine compt)
• R/a
• Resume/accel input
• S134
• S138 (body harn, left rear of engine compt)
• S140
• S152
• S203
• Set sw
• Set/coast input
• Sp200 (body harn, center front of dash)
• Stoplamp switch (brake pedal support bracket)
• Underhood fuse block (on top of left front fender)
• Vehicle speed input
• Vehicle speed sensor (vss) (on rear of transmission)
• Vss
• Vss high
• Vss low