CRUISE CONTROL – GMC Yukon 1999 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

5.7L

5.7L VIN R, Cruise Control Wiring Diagram for GMC Yukon 1999

List of elements for 5.7L VIN R, Cruise Control Wiring Diagram for GMC Yukon 1999:

• (i/p harn, 20 cm from heater/ a/c breakout) s222
• (i/p harn, left rear of engine compt)
• A/t
• A12
• A13
• A14
• A15
• Brake fuse 18 10a
• Clutch pedal position switch (top of clutch pedal)
• Cruise control module (left rear of engine compartment)
• Cruise control switch
• Cruise engage input
• Cruise fuse 6 10a
• Cruise on input
• Engine control system
• Exterior light system
• G119 (right front of engine, near thermostat housing)
• Ground
• Hot at all times
• Hot in run
• I/p fuse block (left side of dash)
• Ignition
• M/t
• Off
• R/a
• Resume/accel sig
• S/c
• S153
• S215
• S220 (i/p harness, 6 cm from steering column harness breakout)
• S221 (i/p harn, 20 cm from cluster breakout)
• S299
• Set/coast sig
• Shift inter- lock system
• Speed sensor input
• Speed sensor output
• Stop/haz fuse 1 20a
• Stoplamp or clutch sw input
• Stoplamp sw input
• Stoplamp switch (top of brake pedal)
• Vcm signal
• Vehicle control module (vcm) (left side of engine compt)
• Vehicle speed sensor (vss) (left side of transmission)
• Vss high
• Vss low