CRUISE CONTROL — GMC Yukon 2000 — SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for GMC Yukon 2000

List of elements for Cruise Control Wiring Diagram for GMC Yukon 2000:

• (i/p harn, 20 cm from heater/ a/c breakout) s222
• (i/p harn, left rear of engine compt)
• A/t
• A12
• A13
• A14
• A15
• Brake fuse 18 10a
• Clutch pedal position switch (top of clutch pedal)
• Cruise control module (left rear of engine compartment)
• Cruise control switch
• Cruise engage input
• Cruise fuse 6 10a
• Cruise on input
• Engine control system
• Exterior light system
• G119 (right front of engine, near thermostat housing)
• Ground
• Hot at all times
• Hot in run
• I/p fuse block (left side of dash)
• Ignition
• M/t
• Off
• R/a
• Resume/accel sig
• S/c
• S153
• S215
• S220 (i/p harness, 6 cm from steering column harness breakout)
• S221 (i/p harn, 20 cm from cluster breakout)
• S299
• Set/coast sig
• Shift inter- lock system
• Speed sensor input
• Speed sensor output
• Stop/haz fuse 1 20a
• Stoplamp or clutch sw input
• Stoplamp sw input
• Stoplamp switch (top of brake pedal)
• Vcm signal
• Vehicle control module (vcm) (left side of engine compt)
• Vehicle speed sensor (vss) (left side of transmission)
• Vss high
• Vss low